Utilitech 148002 Instrucciones de operación

Marca: Utilitech

Modelo: 148002

Tipo: Instrucciones de operación

Este manual también es adecuado para

148001

SUBMERSIBLE UTILITY

PUMP

ITEM #0955646, 0955647

MODEL #148001, 148002

Español p. 9

Serial Number

Purchase Date

Questions, problems, missing parts? Before returning to your retailer, call our customer

service department at 1-866-994-4148, 7:30 a.m. - 5:00 p.m., EST, Monday - Friday.

ATTACH YOUR RECEIPT HERE

AB171076

SW1106 B

PACKAGE CONTENTS

SAFETY INFORMATION

PART DESCRIPTION QUANTITY

A Pump 1

B Adapter 1

Please read and understand this entire manual before attempting to assemble, operate, or install

the product.

• NOTE: Pumps with the “UL” Mark and pumps with the “US” mark are tested to UL Standard

UL778. CSA certied pumps are certied to CSA Standard C22.2 No. 108. (CUS.)

DANGER

• FIRE/EXPLOSION HAZARD.

Pump only clear water. Do not pump ammable or explosive uids such as gasoline, fuel oil,

kerosene, etc. Do not use in a ammable and/or explosive atmosphere. Failure to follow these

warnings could result in death or serious injury and/or property damage.

• RISK OF ELECTRIC SHOCK.

These pumps have not been investigated for use in swimming pool areas.

• RISK OF ELECTRIC SHOCK.

Always disconnect power source before attempting to install, service, or maintain the pump.

Never handle a pump with wet hands or when standing on wet or damp surface or in water. Fatal

electrical shock could occur.

PERFORMANCE

ITEM

NUMBER

HP AMPS

GALLONS PER HOUR AT DISCHARGE HEIGHT

ABOVE PUMPING LEVEL

0 FT. 5 FT. 10 FT. 15 FT.

0955646 1/6 3.0 1,500 1,200 900 540

0955647 1/3 4.5 1,800 1,440 1,140 660

WARNING

CAUTION

• ELECTRICAL SHOCK ALERT.

Before installing this product, have the electrical circuit checked by an electrician to ensure proper

grounding. All electrical installations must conform to the National Electric Code and all local

codes.

• ELECTRICAL SHOCK ALERT.

Connect this product to a properly-grounded 115 volt circuit equipped with a Ground Fault Circuit

Interrupter (GFCI) device.

• ELECTRICAL SHOCK ALERT.

Do not handle pump or pump motor with wet hands or when standing on a wet or damp surface or

in water.

• ELECTRICAL SHOCK ALERT.

These pumps are supplied with a 3-prong grounded plug to help protect you against the possibility

of electrical shock. DO NOT UNDER ANY CIRCUMSTANCES REMOVE THE GROUND PIN.

• ELECTRICAL SHOCK ALERT.

BE CERTAIN the pump power source is disconnected before installing or servicing pump.

• ELECTRICAL SHOCK ALERT.

Protect electrical cord from sharp objects, hot surfaces, oil and chemicals. Avoid kinking the cord.

CHEMICAL ALERT.

This product contains chemicals known to the state of California to cause cancer and birth defects

or other reproductive harm.

• PERSONAL INJURY ALERT.

Provide a means of pressure relief if the pump discharge can be shut off or obstructed. Pumps

operating with a closed discharge can create hot liquid, which can cause burns.

• PERSONAL INJURY ALERT.

This pump is equipped with an automatic thermal overload and can restart without warning.

• PERSONAL INJURY OR PRODUCT DAMAGE MAY RESULT.

Check to be sure your power source is capable of handling the voltage requirements of the motor,

as indicated on the pump name plate.

• PRODUCT DAMAGE MAY RESULT.

These pumps are not designed or intended to be used to handle sewage or efuent.

• PRODUCT DAMAGE MAY RESULT.

This pump has been evaluated for use with WATER only.

• PRODUCT DAMAGE MAY RESULT.

Maximum continuous operating water temperature for standard model pumps must not exceed

104°F (40°C).

• PRODUCT DAMAGE MAY RESULT.

Not designed for continuous, ongoing operation. Design life is 4,500 accumulated hours.

Before beginning assembly of product, make sure all parts are present. Compare parts with package

contents list. If any part is missing or damaged, do not attempt to assemble the product.

Estimated Assembly Time: 5 minutes

No Tools Required for Assembly.

PREPARATION

INSTALLATION INSTRUCTIONS

1. Attach garden hose adapter (B) to the pump

(A) discharge and then connect garden

hose (not included) to adapter (B). DO NOT

OVERTIGHTEN THE GARDEN HOSE OR

HOSE ADAPTER. Hand tight plus an additional

1/4 to 1/2 turn should be sufcient.

2. Place pump (A) in the water on a hard surface.

Pump (A) will operate continuously whether

partially or fully submerged. Avoid placing pump

(A) directly on sand, dirt, or mud.

Hard

Surface

3. Plug pump (A) into a properly grounded 115 V

AC power outlet.

GFCI Outlet

4. Pump (A) has an air valve to prevent air-locking.

Air-locking will keep pump (A) from pumping

water. A small spray of water from the air valve

is normal and does not represent a defective

pump.

Normal

Water

Spray

OPERATING INSTRUCTIONS

1. When the water level at bottom of pump (A)

drops to approximately 3/16 in., pump (A) will

continue to run but will stop moving water.

Unplug pump (A) when water stops owing from

the hose.

RESET

TEST

Unplug

Pump

Low Water

2. DO NOT RUN DRY. Running pump (A) when it

is not submerged in water will damage the seal

and impeller, and void the warranty.

Do not

run dry

CARE AND MAINTENANCE

The motor housing of pump (A) is completely sealed and requires no service. Disassembly of the

motor housing or alteration of the power cord voids all warranty.

1. Periodically unplug pump (A) to inspect the inlet

and remove any debris. Make sure your hands

are dry and that you are not standing in water.

Unplug

pump

Remove

debris

2. If pump (A) clogs, unplug the pump from the

power supply. Attach one end of a garden

hose to a spigot and the other end to pump

(A) discharge. Turn on the spigot to run water

through pump (A) to clean it out.

PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION

Pump runs,

but no water is

discharged.

1. Hose kinked. 1. Straighten hose.

2. Defective pump. 2. Replace pump.

3. Discharge height too great. 3. Reduce discharge height.

4. Clogged inlet. 4. Clean inlet.

Motor runs too hot. 1. Voltage incorrect. 1. Connect to 115 volt outlet.

2. Restricted discharge hose. 2. Increase hose diameter to 3/4 in.

3. Pump damaged. 3. Replace pump.

4. Plugged or kinked discharge. 4. Clean and straighten hose.

Flow rate is low. 1. Hose kinked. 1. Straighten hose.

2. Clogged impeller. 2. Clear obstruction.

3. Excessive length of hose. 3. Reduce length of outlet hose.

Pump will not run. 1. No power. 1. Verify that unit is plugged into 115

volt outlet.

2. Motor overheated. 2. Motor has automatic thermal

protector. Wait 15 minutes for

motor to cool.

TROUBLESHOOTING

WARRANTY

This product is warranted for one year from the date of purchase or two years from the date of

manufacture, whichever occurs rst. Subject to the conditions hereinafter set forth, the manufacturer

will repair or replace to the original consumer, any portion of the product which proves defective due

to defective materials or workmanship. This warranty does not cover replacement parts for failure

due to normal wear and tear. To obtain warranty service, contact the retailer from whom the product

was purchased. The manufacturer retains the sole right and option to determine whether to repair or

replace defective equipment, parts or components. Damage due to conditions beyond the control of

the manufacturer is not covered by this warranty. For warranty questions or service, call 1-866-994-

4148.

THIS WARRANTY WILL NOT APPLY: (a) To defects or malfunctions resulting from failure to properly

install, operate or maintain the unit in accordance with printed instructions provided; (b) to failures

resulting from abuse, accident or negligence; (c) to normal maintenance services and the parts

used in connection with such service; (d) to units which are not installed in accordance with normal

applicable local codes, ordinances and good trade practices; and (e) the unit is used for purposes

other than for what it was designed and manufactured.

RETURN OF WARRANTED COMPONENTS: Any item to be repaired or replaced under this warranty

must be returned to the manufacturer at such place as the manufacturer may designate, freight

prepaid.

THE WARRANTY PROVIDED HEREIN IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES,

AND MAY NOT BE EXTENDED OR MODIFIED BY ANYONE. ANY IMPLIED WARRANTIES SHALL

BE LIMITED TO THE PERIOD OF THE LIMITED WARRANTY AND THEREAFTER ALL SUCH

IMPLIED WARRANTIES ARE DISCLAIMED AND EXCLUDED. THE MANUFACTURER SHALL

NOT, UNDER ANY CIRCUMSTANCES, BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR

SPECIAL DAMAGES, SUCH AS, BUT NOT LIMITED TO DAMAGE TO, OR LOSS OF, OTHER

PROPERTY OR EQUIPMENT, LOSS OF PROFITS, INCONVENIENCE, OR OTHER INCIDENTAL

OR CONSEQUENTIAL DAMAGES OF ANY TYPE OR NATURE. THE LIABILITY OF THE

MANUFACTURER SHALL NOT EXCEED THE PRICE OF THE PRODUCT UPON WHICH SUCH

LIABILITY IS BASED.

This warranty gives you specic legal rights, and you may have other rights which vary from state to

state. Some states do not allow limitations on duration of implied warranties or exclusion of incidental

or consequential damages, so the above limitations may not apply to you.

Printed in China

In those instances where damages are incurred as a result of an alleged pump failure, the

Homeowner must retain possession of the pump for investigation purposes.

BOMBA SUMERGIBLE

PARA USO GENERAL

ARTÍCULO #0955646, 0955647

MODELO #148001, 148002

Número de serie

Fecha de compra

¿Preguntas, problemas, piezas faltantes? Antes de volver a la tienda, llame a nuestro

Departamento de Servicio al Cliente al 1-866-994-4148, de lunes a viernes de

7:30 a.m. a 5:00 p.m., hora estándar del Este.

ADJUNTE SU RECIBO AQUÍ

SW1106S B

CONTENIDO DEL PAQUETE

INFORMACIÓN DE SEGURIDAD

PIEZA DESCRIPCIÓN CANTIDAD

A Bomba 1

B Adaptador 1

Lea y comprenda completamente este manual antes de intentar ensamblar, usar o instalar el

producto.

• NOTA: Las bombas con la marca “UL” y con la marca “US” se prueban para cumplir con los

estándares UL778 de UL. Las bombas con certicación CSA cumplen con el estándar CSA

C22.2 No. 108. (CUS.)

PELIGRO

• PELIGRO DE INCENDIO/EXPLOSIÓN.

Bombee solo agua limpia. No bombee líquidos inamables o explosivos como gasolina,

gasoil, queroseno, etc. No la utilice en una atmósfera inamable o explosiva. No seguir estas

instrucciones puede provocar la muerte, lesiones graves o daños a la propiedad

• RIESGO DE DESCARGA ELÉCTRICA.

No se ha vericado el uso de estas bombas en piscinas.

• RIESGO DE DESCARGA ELÉCTRICA.

Desconecte siempre la fuente de alimentación antes de intentar instalar, reparar, reubicar o

realizarle mantenimiento a la bomba. Nunca manipule la bomba con las manos mojadas ni

cuando esté parado sobre una supercie húmeda o en el agua. Podría ocurrir una descarga

eléctrica fatal.

RENDIMIENTO

NÚMERO

ARTÍCULO

HP AMPERIOS

LITROS POR HORA CON ALTURA DE DESCARGA

POR ENCIMA DEL NIVEL DE BOMBEO

0 M 1,52 M 3,04 M 4,57 M

0955646 1/6 3.0 1,500 1,200 900 540

0955647 1/3 4.5 1,800 1,440 1,140 660