MagicTouch MT350 Using MagicTouch
61
8.3 Operating MagicTouch
Observe the following instructions when you use MagicTouch:
d
Warning: Danger of crushing!
Never allow the electric windows to be closed while they are unattended.
z For the correct operation of the remote control, an interference-free radio
connection is required between transmitter and receiver.
z Depending on the installation situation of the radio receiver and the transmission
power of sources of interference nearby, the range is up to 20 m.
z Each time the hand transmitter is used, it sends a new code (rolling code). For
this reason, the radio receiver might not recognise the hand transmitter immedi-
ately if you use the hand transmitter too frequently without the radio receiver re-
ceiving the transmission signal. In such a case, operate the hand transmitter
again another one to three times; after the third attempt at the latest, the radio
receiver will recognise the hand transmitter again.
Closing the central locking
➤ Press the left-hand blue button on the hand transmitter.
✓ If the ignition is switched off, the hazard light flashes once for confirmation.
Opening the central locking
➤ Press the right-hand blue button on the hand transmitter.
✓ If the ignition is switched off, the hazard light flashes twice for confirmation.
✓ In vehicles with negatively charged door contact: the interior lighting is switched
on and goes out again when the ignition is switched on.
Using the convenience function
If the vehicle is locked, pressing the grey button activates the hand transmitter for
the convenience output. Depending on the setting of the receiver, the output is
switched on on closing the central locking or by pressing the grey button.
✓ The hazard light flashes once for confirmation.
e
Caution!
The maximum output current of 150 mA for the convenience function may
not be exceeded.
If you would like to activate larger consumers, you will need to use an addi-
tional relay (operating current relay) with a recovery diode.
You can also set the convenience function as “coming home function”: during lock-
ing, the dimmed headlight is switched on for 10 s. You can also switch the dipped
headlight on by pressing the grey button for 10 s.
➤ For the coming home function, connect the operating current relay as shown in
fig. e, page 10:
– Connect a red cable from contact 86 to the 15 A fuse element.
MT-350.book Seite 61 Donnerstag, 1. März 2007 4:58 16