CT-45-12(/230), CS-45-12 Operation
19
Lock the box firmly by shutting the cover again and setting the
rotary button to the position “Lock” (see figure 3, page 2, pos. A).
Already after a short period you can convince yourself from the
proper functioning of your ice box at the interior of the cover.
✓The ice box starts to cool or heat the interior space.
Take care that there are only objects or goods in the ice box which
may be cooled or heated to the selected temperature.
➤If you put the ice box out of operation, turn the switch to the
position “OFF” (see figure 4, page 3, pos. G) and disconnect the
connecting cable.
6.4 Use of the battery controller (only CS-45-12)
If you should operate your ice box with a mains rectifier, switch off
the battery controller since the output voltage of the mains rectifier
can be below the restart voltage of the battery controller.
The battery controller protects your vehicle battery from too low a discharge
when connecting to the 12 volts on-board mains. Thus it is ensured that
sufficient energy is available for the vehicle for the starting process.
➤ Push the switch at the control panel to the position “On” (see figure 4,
page 3, Pos. D) in order to switch on the battery controller.
An LED (light emitting diode) at the control panel (see figure 4, page 3,
pos. A) indicates the state of the battery controller.
Push the switch at the control panel to the position “OFF” (see figure 4,
page 3, Pos. D) in order to switch off the battery controller.
Operating display Operating mode
red
(see figure 4, page 3 (Pos C)
Heating
green
(see figure 4, page 3 (Pos B)
Cooling
Operating display Operating mode
LED lights up red The switch-on voltage (13.1 V +- 0.2 V) is available
and the ice box is in operation.
LED flashes red The output voltage (11.7 V +- 0.2 V) is reached and
the battery controller has switched off the ice box.
CT-45-12(230_CS-45-12_230.book Seite 19 Mittwoch, 4. Februar 2004 1:42 13