SERIOUS BODILY INJURY OR DEATH CAN RESULT IF THIS
PRODUCT IS NOT INSTALLED AND USED CORRECTLY.
IMPORTANT NOTICE - Attention Installer:
IN CANADA: THE CONVERSION SHALL BE CARRIED OUT IN ACCORDANCE WITH THE
REQUIREMENTS OF THE PROVINCIAL AUTHORITIES HAVING JURISDICTION AND IN
ACCORDANCE WITH THE REQUIREMENTS OF THE NATURAL GAS AND PROPANE
INSTALLATION CODE CSA B149.1
INSTALLERS, POOL OPERATORS AND POOL OWNERS MUST
READ THESE WARNINGS AND ALL INSTRUCTIONS BEFORE
USING THE ETi® 400 HIGH EFFICIENCY HEATER.
IMPORTANT WARNING AND SAFETY INSTRUCTIONS
Failure to follow instructions could result in fire or explosion with
serious injury or property damage. This conversion kit shall be installed
by a qualified service agency in accordance with the manufacturer’s
instructions and all applicable codes and requirements of the
authority having jurisdiction. The information in these instructions must
be followed to minimize the risk of fire or explosion or to prevent
property damage, personal injury, or death. The qualified service agency
is responsible for the proper installation of this kit. The installation is not
proper and complete until the operation of the converted appliance is
checked as specified in the manufacturer’s instructions supplied with the
kit.
ETi 400 High Efficiency Heater Combustion Blower Replacement Kit Installation Guide
IMPORTANT WARNING AND SAFETY INSTRUCTIONS
Risk of fire or explosion from incorrect fuel use or faulty fuel
conversion. Do not try to run a heater set up for natural gas on propane
gas or vice versa. Only qualified service technicians should attempt to
convert heater from one fuel to the other. Do not attempt to alter the
rated input or type of gas by changing the orifice. If it is necessary to
convert to a different type of gas, consult your Pentair dealer.
Serious malfunction of the burner can occur which may result in loss
of life. Any additions, changes, or conversions required in order for the
appliance to satisfactorily meet the application needs must be made by
a Pentair dealer or other qualified agency using factory specified and
approved parts.
Risk of explosion if a unit converted to propane gas is installed in a
pit or other low spot. Propane is heavier than air. Do not install the heater
using propane in pits or other locations where gas might collect.
Consult your local building code officials to determine installation
requirements of heater relative to propane storage tanks and filling
equipment. In Canada, Installation must meet the requirements of the
Standard for the Storage and Handling of Liquid Petroleum Gases,
CAN/CSA B149.1 (latest edition). In the U.S. installation must meet the
requirements of the Standard for the Storage and Handling of Liquefied
Petroleum Gases, ANSI/NFPA 58 (latest edition). Consult local codes and
fire protection authorities about specific installation restrictions.
Propane (LPG) fired heaters must not be installed in garages in
Massachusetts, by order of the Massachusetts State Fire Marshall. For
more information, call the Fire Marshall’s office.
IN CANADA: “THIS KIT SHALL BE CARRIED OUT IN ACCORDANCE WITH
THE REQUIREMENTS OF THE PROVINCIAL AUTHORITIES HAVING
JURISDICTION AND IN ACCORDANCE WITH THE REQUIREMENTS OF
THE CAN-B149.1 AND CAN-B149.2 INSTALLATION CODE.”
ETi 400 High Efficiency Heater Combustion Blower Replacement Kit Installation Guide
Gas Connections
These instructions are for the use of qualified service technicians only!
Do not attempt this procedure unless you have been trained and certified in the care
and repair of gas-fired appliances!
Do not attempt this procedure if you are not confident about following instructions!
NOTICE:
INSTRUCTIONS FOR CHECKING THE GAS PRESSURE THROUGH THE
COMBINATION GAS CONTROL VALVE.
ETi 400 High Efficiency Heater Combustion Blower Replacement Kit Installation Guide
Fire and explosion hazard. The Air Orifice is sized specifically for the air/gas
mixture required by the burner. Do not modify the Air Orifice or replace it with
an orifice of a different size.
Fire and explosion hazard. The Combustion Blower handles a combustible
air/gas mixture. When servicing this part, check all seals for tightness to
ensure that the Blower is not leaking.
Replacing Combustion Blower
Turn off the electrical supply to the
heater; turn off the pump; shut off the
manual gas supply valve to the heater.
ETi 400 High Efficiency Heater Combustion Blower Replacement Kit Installation Guide
Fuel Recommended CO2
(Dry Basis)
NG 7.80% – 9.2%
Propane 9.6% – 10.2%
Note: When checking for leaks, raise the blower’s outlet pressure by
blocking the flue or vent body with your hand.
Replacing Combustion Blower (Continued)
Union
Union
Gas-train Union
2UL¿FH
ETi 400 High Efficiency Heater Combustion Blower Replacement Kit Installation Guide
1620 HAWKINS AVE., SANFORD, NC 27330 • (919) 566-8000
10951 WEST LOS ANGELES AVE., MOORPARK, CA 93021 • (805) 553-5000
WWW.PENTAIRPOOL.COM
All Pentair trademarks and logos are owned by Pentair or one of its global affiliates. ETi® and
Sta-Rite® are registered trademarks of Pentair Water Pool and Spa, Inc. and/or its affiliated
companies in the United States and/ or other countries. Unless expressly noted, names and
brands of third parties that may be used in this document are not used to indicate an affiliation or
endorsement between the owners of these names and brands and Pentair Water Pool and Spa, Inc.
Those names and brands may be the trademarks or registered trademarks of those third parties.
Because we are continuously improving our products and services, Pentair reserves the right to
change specifications without prior notice. Pentair is an equal opportunity employer.
© 2017 Pentair Water Pool and Spa, Inc. All rights reserved. This document is subject to change
without notice.
P/N 476110 REV. A 11/2017
*476110*
GUÍA DE INSTALACIÓN
CALENTADOR DE ALTA EFICIENCIA
PARA PISCINAS ETi® 400
KIT DE REEMPLAZO DEL SOPLADOR
A COMBUSTIÓN
N/P 476000
¡IMPORTANTE!
¡ADVERTENCIA! PARA SU SEGURIDAD: ESTE PRODUCTO DEBE SER
INSTALADO Y MANTENIDO POR PERSONAL DE SERVICIO AUTORIZADO,
CON CALIFICACIÓN PARA INSTALACIONES DE PISCINAS/SPA
1620 HAWKINS AVE., SANFORD, NC 27330 • (919) 566-8000
10951 WEST LOS ANGELES AVE., MOORPARK, CA 93021 • (805) 553-5000
WWW.PENTAIRPOOL.COM
Todas las marcas comerciales y los logotipos de Pentair son propiedad de Pentair o de alguna de sus filiales
internacionales. ETi® y Sta-Rite® son marcas comerciales registradas de Pentair Water Pool and Spa, Inc.
y/o de sus filiales en los Estados Unidos y/o en otros países. A menos que se indique expresamente, los
nombres y las marcas de terceros que puedan usarse en este documento no se usan para mostrar una
asociación o un respaldo entre los propietarios de estos nombres y marcas y Pentair Water Pool and Spa,
Inc. Dichos nombres y marcas pueden ser marcas comerciales o marcas registradas de esos terceros. Como
mejoramos continuamente nuestros productos y servicios, Pentair se reserva el derecho de modificar las
especificaciones sin previo aviso. Pentair es un empleador que ofrece igualdad de oportunidades.
© 2017 Pentair Water Pool and Spa, Inc. Todos los derechos reservados. Este documento está sujeto a
cambios sin previo aviso.
P/N 476110 REV. A 9/2017
*476110*
Guide d’installation de la trousse de remplacement du ventilateur de combustion
du chauffe-piscine au gaz à rendement élevé ETi 400
12
WWW.PENTAIRPOOL.COM
Toutes les marques de commerce et tous les logos Pentair appartiennent à Pentair ou à l’une de
ses filiales dans le monde. ETi® et Sta-Rite® sont des marques déposées de Pentair Water Pool and
Spa, Inc. ou de ses filiales aux États-Unis et dans d’autres pays. À moins d’avis explicite, les noms
et marques de tierces parties susceptibles d’être utilisés dans ce document ne sont pas destinés à
indiquer une affiliation entre les propriétaires de ces noms et marques et Pentair Water Pool and
Spa, Inc. ni un appui de ceux-ci. Ces noms et marques peuvent être les marques de commerce ou
les marques déposées de ces tierces parties. Dans la mesure où Pentair améliore constamment
ses produits et services, la société se réserve le droit d’en modifier les spécifications sans préavis.
Pentair est un employeur offrant l’égalité professionnelle.
modifications sans préavis.
Nº de pièce 476110 RÉV. A 11/2017
*476110*
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
En otros idiomas
- français: Pentair ETi 400 Guide d'installation
- English: Pentair ETi 400 Installation guide
Documentos relacionados
Otros documentos
-
STA-RITE MAX-E-THERM Guía del usuario
-
Empire Heating Systems Gravity Wall Furnace (GWT50W) El manual del propietario
-
Empire HW350 El manual del propietario
-
Empire Heating Systems GWT25/35W El manual del propietario
-
-
Mr. Heater MHU125NG El manual del propietario
-
HeatStar HSU80NG El manual del propietario
-
HeatStar 8944977 El manual del propietario