Andersen Lock Mechanism Handing Change Service Instructions
- Tipo
- Service Instructions
Lock Mechanism Handing Change
9069263 BA Revised 09/03/13
Tools Needed Herramientas necesarias
∙Safety Glasses Lentes de seguridad
∙1/8" Screwdriver
∙5/32" Hex Key
for E-Series Hinged Inswing and Outswing Double French Patio Doors
Use caution when working at elevated heights and around unit openings.
Follow manufacturers’ instructions for ladders and/or scaffolding. Failure
to do so may result in injury or death.
Sea cauteloso al trabajar en lugares elevados y cerca de las aberturas de
la unidad. Siga las instrucciones del fabricante para el uso de escaleras
y/o andamios. Si no lo hiciera, podrían producirse lesiones o la muerte.
Follow manufacturers’ instructions for hand or power tools. Always
wear safety glasses. Failure to do so may result in injury and/or
product damage.
Siga las instrucciones del fabricante para el uso de herramientas
eléctricas o manuales. Utilice siempre gafas de seguridad. Si no lo
hiciera, podrían producirse lesiones y/o daños al producto.
Thank you for choosing Andersen. / Gracias por elegir Andersen.
For questions call 1-888-888-7020. For more information and/or guides visit www.eaglewindow.com.
Please leave this guide with building owner.
Si tiene alguna pregunta llame al 1-888-888-7020. Para obtener más información y/o guías, visite www.eaglewindow.com
Deje esta guía con el dueño de la construcción.
▶Read guide from beginning to end before starting installation. Read all warnings and cautions during unit installation.
Lea completamente la guía antes de comenzar la instalación. Lea y respete todas las advertencias y precauciones durante la instalación de la unidad.
▶Check with your local building code ofcial to identify and conrm compliance with local building code requirements.
Consulte los códigos locales de construcción para identicar y conrmar que se cumplan los requisitos del código de construcción.
Lock Mechanism
“Andersen” and all other marks where denoted are trademarks of Andersen Corporation and its subsidiary. ©2013 Andersen Corporation. All rights reserved.
Insert 1/8" at blade screwdriver in reversal slot on center latch.
Rotate center latch 180º.
2
1
3
5
2
4
6
Apply pressure with screwdriver and pull center latch outwards.
Push center latch back into lock mechanism until it clicks into place.
Insert 5/32" hex key into reversal hole of top latch and loosen screw,
pull latch outwards.
Rotate 180º, push back into lock mechanism and tighten screw. Repeat
Steps 5 & 6 for bottom latch.
9069263
▶Lock mechanism handing change is complete.
Hardware replacement is completed.
Flat Blade
Screwdriver
Flat Blade
Screwdriver
Center Latch
Top/Bottom Latch
Top/Bottom Latch
5/32" Hex Key
5/32" Hex Key
Center Latch
Center Latch
Center Latch
Reversal Slot Reversal Slot
Lock Mechanism
Top/Bottom Latch
Center Latch
-
1
-
2
Andersen Lock Mechanism Handing Change Service Instructions
- Tipo
- Service Instructions
en otros idiomas
Artículos relacionados
-
Andersen 9007541 Guía de instalación
-
none 9007541 Guía de instalación
-
-
-
-
-
-
Andersen 9122368 Guía de instalación