Andersen Lock Mechanism Handing Change Service Instructions

Tipo
Service Instructions
Lock Mechanism Handing Change
9069263 BA Revised 09/03/13
Tools Needed Herramientas necesarias
Safety Glasses Lentes de seguridad
1/8" Screwdriver
5/32" Hex Key
for E-Series Hinged Inswing and Outswing Double French Patio Doors
Use caution when working at elevated heights and around unit openings.
Follow manufacturers’ instructions for ladders and/or scaffolding. Failure
to do so may result in injury or death.
Sea cauteloso al trabajar en lugares elevados y cerca de las aberturas de
la unidad. Siga las instrucciones del fabricante para el uso de escaleras
y/o andamios. Si no lo hiciera, podrían producirse lesiones o la muerte.
Follow manufacturers’ instructions for hand or power tools. Always
wear safety glasses. Failure to do so may result in injury and/or
product damage.
Siga las instrucciones del fabricante para el uso de herramientas
eléctricas o manuales. Utilice siempre gafas de seguridad. Si no lo
hiciera, podrían producirse lesiones y/o daños al producto.
Thank you for choosing Andersen. / Gracias por elegir Andersen.
For questions call 1-888-888-7020. For more information and/or guides visit www.eaglewindow.com.
Please leave this guide with building owner.
Si tiene alguna pregunta llame al 1-888-888-7020. Para obtener más información y/o guías, visite www.eaglewindow.com
Deje esta guía con el dueño de la construcción.
Read guide from beginning to end before starting installation. Read all warnings and cautions during unit installation.
Lea completamente la guía antes de comenzar la instalación. Lea y respete todas las advertencias y precauciones durante la instalación de la unidad.
Check with your local building code ofcial to identify and conrm compliance with local building code requirements.
Consulte los códigos locales de construcción para identicar y conrmar que se cumplan los requisitos del código de construcción.
Lock Mechanism
Andersen” and all other marks where denoted are trademarks of Andersen Corporation and its subsidiary. ©2013 Andersen Corporation. All rights reserved.
Insert 1/8" at blade screwdriver in reversal slot on center latch.
Rotate center latch 180º.
2
1
3
5
2
4
6
Apply pressure with screwdriver and pull center latch outwards.
Push center latch back into lock mechanism until it clicks into place.
Insert 5/32" hex key into reversal hole of top latch and loosen screw,
pull latch outwards.
Rotate 180º, push back into lock mechanism and tighten screw. Repeat
Steps 5 & 6 for bottom latch.
9069263
Lock mechanism handing change is complete.
Hardware replacement is completed.
Flat Blade
Screwdriver
Flat Blade
Screwdriver
Center Latch
Top/Bottom Latch
Top/Bottom Latch
5/32" Hex Key
5/32" Hex Key
Center Latch
Center Latch
Center Latch
Reversal Slot Reversal Slot
Lock Mechanism
Top/Bottom Latch
Center Latch
  • Page 1 1
  • Page 2 2

Andersen Lock Mechanism Handing Change Service Instructions

Tipo
Service Instructions

En otros idiomas