Steren HER-252 El manual del propietario

  • ¡Hola! Soy un chatbot de IA específicamente entrenado para ayudarte con el Steren HER-252 El manual del propietario. He revisado el documento y puedo ayudarte a encontrar la información que necesitas o explicarla de manera clara y sencilla. ¡Pregunta lo que necesites!
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Problema Solución
No se puede establecer la conexión
con el receptor o los tonos son
débiles
· Compruebe que el control de
volumen en el receptor esté en la
posición correcta.
· Revise el estado de las baterías (en
el transmisor y en el receptor); en
caso de ser necesario, reemplácelas.
· Asegúrese de que el interruptor
en el receptor esté en la posición
“SCAN” o “LED”.
El transmisor no detecta la señal del
equipo de telecomunicaciones
· Puede haber conicto entre la señal
de la línea y la señal del transmisor.
Reinicie el dispositivo.
Resultados incorrectos en el mapeo
de cables
· Asegúrese de que los conectores
sean RJ45 / RJ11 y de que los cables
estén bien conectados.
· Si los indicadores LED no funcionan
adecuadamente, probablemente
estén dañados, acuda con un distri-
buidor autorizado para una revisión
del equipo.
El receptor no detecta voltaje sin
contacto (NCV)
· Compruebe que el interruptor esté
en la posición NCV.
· Mantenga presionado el botón
“SCAN” mientras realiza la búsqueda.
· Revise el estado de la batería.
18
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
Trouble Solution
It cannot establish the connection with
the receiver or the tones are weak
· Check that the volume control in the
receiver is in right position.
· Review the batteries status (in both
devices) if is necessary change it.
· Ensure that the switch in the recei-
ver is in the “SCAN” or “LED”position.
The transmitter does not detects
the signal in the telecommunication
equipment
· Maybe there is conict between the
phone line signal and the transmitter
signal. Restart your device.
Wrong results in the cable mapping
· Ensure that the connectors are
RJ45/RJ11 and the cables are con-
nected correctly.
· If the LED indicators don’t works,
probably are damaged, refers to an
authorized dealer to make a revision
of the equipment.
The NCV function does’not works
· Check that the switch is in the
correct position.
· Press and hold the SCAN button
while you search.
· Review the battery status.
36
37
/