P06835 - Rev. 1
GUARANTEE DOCUMENT
Motoppar, Industry and Commerce of Automatic Gate Openers Ltd., Located at 3526 Dr. Labieno da Costa
Machado Avenue, Industrial District, Garça –SP, Zip Code 17400-000, National Registry of Legal Entities Num-
ber 52.605.821/0001-55, State Registration Number 315.011.558.113 hereby guarantees this product against
design, manufacturing or assembly defects that could make its intended use improper or inadequate, within
a legal period of 90 (ninety) days from time of acquisition. In order to make this guarantee feasible and liable,
the installation instructions must be properly followed. In case the law requires it, one must hire a qualied
and technically trained person to install the product, with the collection of the corresponding Technical Term
of Responsibility.
In case of defect, within the warranty period, MOTOPPAR responsibilities are restricted to the repair or subs-
titution of the product manufactured by the company, not including the removal or reinstallation costs, as well as
the transportation to the manufacturer costs.
Due to the credibility and trust placed on PPA products, we will add 275 more days to the period mentioned
above reaching a guarantee period of one year, likewise counted from the time of acquisition proven by consumer
through proof of purchase. Within the additional period of 275 days, only visits and transportation intended to
potential product repairs will be charged. In places where authorized technical assistance is available, the cost of
transportation of the product and/or technician will be responsibility of the consumer.
The substitution or repair of the product does not prolong the guarantee.
his guarantee will be terminated if the product:
- Is damaged by accidents or natural agents, such as lightning, oods, landslides, re etc.;
- Is installed in an improper electric power supply or if it is not according to what any of the installation
instructions from the manual;
- Is affected by an electrical discharge that affects its proper functioning;
- Is not used for its intended purpose;
- Is not used under normal conditions or damaged because of vandalism;
- Is damaged by accessories or equipment connected to it or other peripheral device by other manufacturers
which cause the product to be inoperative;
- Interruption of use, which can make the device obsolete or out-of-date, thus entailing operational problems;
- Lack of attention on the batteries expiry dates as well as their proper maintenance.
Recommendation:
We recommend the operator installation and maintenance to be performed by an authorized PPA technical
service.
Installation done by a third party will terminate the guarantee due to damage caused by inadequate ins-
tallation.
Only a PPA authorized technician is qualied to open, remove, and substitute parts or components, as well
as repair defects covered by this guarantee; failure on observing this guideline and the veried use of any non-
-original parts will cause the resignation of this guarantee document on the part of the user.
In case a phone line is either not transmitting data or out of order, there will be limitations to the alarm
system. Thus, it is recommended to keep the proper functioning and maintenance of the phone lines, as well
as of the power grid.
The manufacturer will not be held responsible in case there is a power cut or a problem on the phone line,
or any other event that interrupts such services, and possibly affects the good and practical functioning of the
devices, this will lead to exemption of responsibility of the manufacturer. Thus, we strongly recommend particular
attention to the supply of such services.
We also recommend a periodic or scheduled (every 30 days) maintenance, with a technical visit of the person
responsible for the installation.
The products are only intended to decrease or prevent risk (of theft or robbery) but do not assure such events
will not occur. They are products aimed to a means and not to an outcome, so we strongly recommend that,
even with the installation of our products, the consumer act prudently in order to protect themselves and keep
the security of their life and estate.
If the product fails, seek an Authorized Technical Service to x it.
Purchaser: _______________________________________________________________________________
Address: _________________________________________________________________________________
City / Province / Town: _______________________________________________________________________
District / Neighborhood: _____________________________________________ ZIP Code: _________________
Seller: ___________________________________________________________________________________
Phone Number: ________________________________________ Date of Purchase: _____/_____/_________
ID: ________________________________________________________________________________
After the gate opener has been turned off and the strength has been stored on the
device’s memory, according to the programming described on the technical manual
of the control unit of the gate opener, the “SN” LED starts blinking every second and
the courtesy light / trafc light starts waiting for the porogramming.
Courtesy light:
The courtesy light remains activated du-
ring the opening / closing displacement of
the gate and turns itself off after a preset time
interval after the gate closes and the control
unit reaches the Closing Limit Switch. This
time interval must be set by pressing the right
button on the remote control and by using a
watch or clock to calculate the seconds.
Trafc light:
The trafc light remains activated during the ope-
ning / closing displacement of the gate and turns itself off
immediately after the closing displacement is over and the
control unit reaches the Closing Limit Switch. Set the trafc
light by pressing and releasing the left button of the remote
control.
In order to nish the programming, open the
“PROG” jumper.
WARNING
If the “PROG” jumper is open, the unit
control will nish the automatic programming,
keeping the previous settings.
!
CONTROL UNIT OF THE GATE OPENER
RELAY MODULE
(COURTESY LIGHT /
TRAFFIC LIGHT)
127 VAC / 220 VAC
NANF