6
Setting Up your Dualbrew Single Serve Coffee Maker Using the Capsule Adaptor
WARNING: Before brewing, it is recommended the water tank be lled at least to the lowest 6-oz. step.
To avoid damage to your Coffee Maker, never operate your Single Serve Coffee Maker when the water tank
is empty.
1. Lift the water tank lid located at the top back of the unit. (See Figure 1.)
2. Using the desired cup, mug, or tumbler as your measure, add water to the water tank. The water tank
has an easily visible, stepped water level indicator. Add water to the desired ll line to brew one cup
of any hot beverage. The level indicator marks 6-oz., 10-oz., and 15-oz. However, any amount of water
may
be added. DO NOT EXCEED the 15-oz. MAX ll line.
3. Lower the lid.
IMPORTANT: For optimal avor, distilled water is preferred.
4. Position the cup under the nozzle and onto the center of the drip
tray
cover.
5. Pull the adaptor compartment’s front tab up to unlock and lift
the lid.
6. Choose the capsule adaptor. Add the capsule of your choice
into the adaptor. Press down on the capsule until it is ush
with
theadaptor. You will hear a pierce as the needle penetrates
the capsule.
7. With the handle facing front, place the capsule adaptor into
theadaptor
compartment. Slide the adaptor handle into the grooves at
the front
of
the Coffee Maker. (See Figure 5.)
8. IMPORTANT: Press the adaptor compartment’s lid down rmly.
An audible click can be heard as the lid is locked rmly into position,
and the top of the capsule will be punctured.
9. Plug the Coffee Maker into a 120V AC electrical wall outlet.
10. Press the
button to begin the brew cycle.
11. The red PREHEAT indicator light will begin to ash as the Coffee
Maker begins heating the water.
12. When the water has reached the optimum temperature, the preheat
light will go out and the blue BREW light will illuminate.
13. The pump will then activate and coffee will begin to stream through the nozzle.
14. To interrupt the brewing cycle at any time, press the
button. Then remove the plug from the wall
outlet.
15. At the end of the cycle, the Coffee Maker and all indicator lights will automatically turn OFF.
16. Allow unit to cool before removing the used capsule to discard.
17. Unplug the Coffee Maker when not in use.
Setting Up your Dualbrew Single Serve Coffee Maker Using the Ground Coffee Adaptor
The ground coffee adaptor allows you to create your own favorite blend of coffee. Personalize your blends
by adding a dash of cinnamon, orange peel, cardamom or vanilla bean for avoring, to name a few options.
NOTE: For best results, use medium ground coffee.
WARNING: Before brewing, it is recommended the water tank be lled at least to the lowest 6-oz. step.
To avoid damage to your Coffee Maker, never operate your Single Serve Coffee Maker when the water tank
is empty.
1. Lift the water tank lid located at the top back of the unit. (See Figure 1.)
2. Using the desired cup, mug, or tumbler as your measure, add water to the water tank. The water tank
has an easily visible, stepped water level indicator. Add water to the desired ll line to brew one cup
of
any hot beverage. The level indicator marks 6-oz., 10-oz., and 15-oz. However, any amount of water
may be added. DO NOT EXCEED the 15-oz. MAX ll line.
3. Lower the lid.
IMPORTANT: For optimal avor, distilled water is preferred.
4. Position the cup under the nozzle and onto the center of the drip tray cover.
5. Pull the adaptor compartment’s front tab up to unlock and lift the lid.
6. Choose the ground coffee adaptor. Fill the reusable ground coffee adaptor to the designated ll line,
or to taste. DO NOT EXCEED the MAX ll line. It is recommended to use one 1 tbsp of ground coffee for
every cup of water.
BREW
PREHEAT
Figure 5
Capsule
SO-316143_14814-14815-14816_BELLA ULTIMATE ELITE_ Dual brew Single Serve CM_Khols_IM_R0.indd 6 2019-03-21 2:35 PM