QUICK GUIDE
MI-PMU16 Version 1.0 2/2
1. Insert the batteries in their compartment.
2. Turn on the unit from rear power switch, the LED will light green. The LED will change to red in case of low battery. The battery level is
also indicated on the display.
3. To enter the settings, press the SET key for 2 seconds, then press SET to switch among menus. The menus are as follows: Group /
channel, Frequency, Sensitivity (± 15), RFP (emission power Lo 10mW, Hi 50 mW), LC (high pass filter), and AutoOff (auto off in 1, 10
or 30 minutes without speaking).
4. Set desired group and channel, this must be the same for the microphone and the receiver. When two or more transmitters and
receivers are being used in the same location, they must be set up to use different channels. If selected channel is being interfered,
please change to non-interference channel.
* Note: Please contact your national frequency authority to get information on the available legal frequencies for your area and legal use of the
equipment.