JUICING
1.Before using, please confirm the button switch of the main machine in stop state,
in this way, in case assembly is not completed, starting the main machine can be
avoided, so unnecessary damage for persons or property avoided.
2. Before juicing, first confirm that the appliance is assembled and that it is all in
place adequately.
3. For using, assemble according to the diagram of "name and position of main
components". Turn on power supply, press switch to let the machine run no-load for
5 seconds. Put prepared vegetable or fruit into feed port of the juicer, press with the
pushing bar, evenly, hard and slowly, juice of the vegetable or fruit can be found,
original, fresh, good for health.
4. Note: when pressing food with the pushing bar, force shall be even or indirect,
pressing force shall not be more than 1 kg, no too sudden force, otherwise, juicing
effect will be reduced.
OPERATING TIME
After operating for 1 minute, stop for 1 minute for reuse. After the previous
operation has been carried out three times, stop 15 minutes and do not operate until
the engine cools, then the useful life of the appliance will be longer and more
efficient.
ATTENTIONS
1. Before using, put this machine on a stable and even table board, operate according
to the above methods.
2. Before juicing, first confirm that the appliance is assembled and that it is all in
place adequately.
3. When using the appliance for the first time, the engine may give off a slight and
peculiar smell, this is normal, after the engine has been running for some time, the
previous phenomenon will disappear.
4. During juicing, make sure there is not too full juice and residue in the middle seat
and residue cup, if too full, please cut off power supply, clean up, then use again.
5. During using, do not open the cup cover. In case power supply is on, do not put
hand or any ware into feed port, otherwise, harmful accident may occur or this
machine may be damaged.
6. In order to prolong service life of this machine, over-temperature protective device
is mounted in the motor. If the motor works for a long time or overloaded, when
over warning temperature, power supply will automatically cut off. After the motor
stops, pull out plug of power supply, wait for the motor to cool (about for 30 min),
use again.
7. All accessories of this appliance are NOT dishwasher safe. Neither can be washed
with abrasive cleaners. Only wash with water and neutral soap.