8 US-EN
responds to the specifications on the
rating plate. The wall socket must
continue to be easily accessible af-
ter the device is plugged in.
~Ensure that the power cable cannot
be damaged by sharp edges or hot
points. Do not wrap the power ca-
ble around the device.
~The device is not fully disconnected
from the power supply, even after it
is switched off. In order to fully dis-
connect it, pull out the power plug.
~When using the device, ensure that
the power cable cannot be trapped
or crushed.
~When removing the power plug
from the wall socket, always pull the
plug and never the cable.
~Disconnect the power plug from the
wall socket…
…if there is a fault,
…when you are not using the mutri-
tion-mixer,
…during thunderstorms.
~
Do not use the device if there is visible
damage to the device or the power
cable.
~To avoid any risk, do not make
modifications to the device.
Risk of injury from cutting
~The blades of the blade attachment
carry on rotating after the device
has been switched off. Wait until
the blades have come to a standstill
before you remove the hand blend-
er out of a jug.
~Never reach into the rotating
blades. Do not touch rotating parts
with spoons or similar utensils. Keep
long hair or loose clothing away
from rotating parts as well.
~The blades of the blade attachment
are sharp. Please be very careful
when handling them. When wash-
ing manually, the water should be
sufficiently clear that you can see
the blades easily.
Risk of material damage
~Thick or firm peels, (e.g. of citrus
fruits, pineapple), stems and pips of
stone fruits (e.g. cherries, peaches,
apricots) must be removed before
blending.
~The device is designed for a maxi-
mum operating time of 60 seconds
without interruption (see “Operating
times” on page 10).
~In order to prevent damage to the
device, interrupt the blending pro-
cess immediately if the blades of the
blade attachment rotate with diffi-
culty or not at all. Pull out the power
plug and investigate whether there
is an obstruction in the blender jug
or whether the contents are too vis-
cous. Also check whether the device
is assembled correctly.
~Do not operate the device with emp-
ty blender jugs, as this causes the
motor to overheat and may result in
it being damaged.
~Only operate the device when the
blade attachment is screwed onto.
~Do not use the device for boiling
liquids or during the cooking pro-
cess.
__329792_Stick_blender_B9.book Seite 8 Freitag, 20. September 2019 8:44 08