Modern Forms WS-3111 Vogue Instrucciones de operación
- Tipo
- Instrucciones de operación
1
modernforms.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company’s continuous improvement program.
INSTALLATION INSTRUCTION
Vogue
WS-3111, WS-3111F, WS-3115, WS-3115F
HARDWARE
A1 B1 C1 D1 E1 F1
Wire
Connector
Qty: 3
7EAC112201
Junction Box
Screw
Qty: 2pcs + 1
Extra
7MPF0415C2
#8-32X9/16” SS
Mounting Screw
Qty:1 Extra
4MPF0412S3BW(BZ)
7MPF0412S1(BN)(CH)
5/32-32X1/2”
Bronze/Nickel Plating
Glass Holder
Qty: 1 pc
4MBC290602B2(BZ)
4MBC290602BN1(BN)
4MBC290602CH(CH)
1/8-40X7/16”
Bronze/Brushed
Nickel/Chrome
Glass Bae
Qty: 1 pcs
4MBC544501BZ1(BZ)
4MBC544501BN1(BN)
4MBC544501CH(CH)
Bronze/Brushed
Nickel/Chrome
Fixture Screw
Qty: 2 pcs + 1 Extra
4MPF0411C1BW(BZ)
7MPF0307C1(BN)(CH)
1/8-40X7/16”
Bronze/Nickel Plating
WARNING
IMPORTANT: NEVER attempt any work without shutting o the electricity.
- Read all instructions before installing.
- System is intended for installation by a qualied electrician in accordance with the National Electrical Code and local regulations.
- Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or switch ”OFF”
the circuit breaker switch(es) that control the power to the xture or room that you are working on.
- Place the wall switch in the “OFF” position.
CAUTION
- All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are
worn out or broken. Failure to follow this instruction could invalidate the ETL/CETL listing of this xture.
CAUTION When handling the xture, do not apply pressure to the LEDs. Hold the xture by the base only.
AVERTISSEMENT
IMPORTANT : Coupez l’électricité avant TOUTE manipulation.
- Lisez toutes les instructions avant d’installer.
- Système est destiné à être installé par un électricien qualié en conformité avec le code national de
l’électricité et les règlements locaux.
- Accédez au panneau central de disjoncteurs ou de fusibles de votre demeure et placez l’interrupteur principal
en position d’arrêt (« OFF »).
- Placez l’interrupteur mural en position d’arrêt (« OFF »).
MISE EN GARDE
- Toutes les pièces doivent être utilisées tel qu’il est indiqué dans ces instructions. Ne remplacez pas les pièces,
n’en laissez pas de côté et ne les utilisez pas si elles sont usées ou brisées. Le non-respect de ces
instructions peut annuler l’homologation ETL/CETL du luminaire.
MISE EN GARDE
Ors de la manipulation de l’appareil, ne pas appliquer de pression à la LED, tenir l’appareil par la seule base.
ADVERTENCIA
IMPORTANTE: NUNCA intente hacer trabajos sin desconectar el suministro eléctrico.
- Lea y comprenda todas las instrucciones e ilustraciones por completo antes de proceder con el ensamblaje e
instalación de esta lámpara.
- Sistema está disenado para ser instalado por un electricista calicado, de acuerdo con el código eléctrico nacional y las normas locales.
- Diríjase a la caja de fusibles o a la caja del interruptor de circuito principal en su hogar. Coloque el interruptor
de alimentación principal en la posición “OFF” (APAGADO).
- Coloque el interruptor de la pared en la posición “OFF” (APAGADO).
PRECAUCIÓN
- Todas las piezas deben usarse como lo indican estas instrucciones. No reemplace las piezas, noomita piezas
durante la instalación ni utilice piezas gastadas o rotas. El incumplimiento de esta indicación podría invalidar
la calicación ETL/CETL esta lámpara.
PRECAUCIÓN Al manipular el aparato, no aplique presión a los LED, mantenga el aparato en la base sólo.
2
modernforms.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company’s continuous improvement program.
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (C1) from the xture.
4. Secure the mounting back plate to the junction box using junction box screws (B1). The side of the mounting back plate marked “GND” must
face out.
CONNECTING THE WIRES (Fig. 2)
5. Connect the xture’s wires to junction box wires as shown in Fig. 2,
making sure that all wire connectors (A1) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground wire
to it. Otherwise, connect the xture’s ground wire directly to the back plate
using the green screw provided. After wires are connected, tuck them
carefully inside the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
6. Slide the glass into the front bracket. Place the cover plate (E1) and
glass holder (D1) over the glass and secure with screws (F1).
7. Place the canopy plate over the mounting back plate; secure it with
the mounting screw (C1).
INSTALLATION INSTRUCTION
Vogue
WS-3111, WS-3111F, WS-3115, WS-3115F
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
WS-3111/WS-3111F Back Plate Dimensions
WS-3115/WS-3115F Back Plate Dimensions
Junction Box
A1 Wire Connector
B1 Junction Box Screw
Ground Wire
Mounting Backplate
Front Bracket
Canopy Plate
Mounting Screw
C1
F1 Fixture Screw
D1
Glass Holder
E1
Cover Plate
Glass
WS-3111/WS-3111F: (RPL-GLA-3111)
WS-3115/WS-3115F: (RPL-GLA-3115)
4 1/8”
1 3/4”
1 3/8”
4 1/2”
6 3/8”
1 3/8”
1 3/4”
4 1/8”
-
1
-
2
Modern Forms WS-3111 Vogue Instrucciones de operación
- Tipo
- Instrucciones de operación
En otros idiomas
Documentos relacionados
-
Modern Forms WS-W18708 Oslo Instrucciones de operación
-
-
-
-
-
-
-
-
-
