4. Power on:
1) Before use the heater, please make sure all power sockets are 220V-240V/
-50/60HZ, with the bearable current greater than 15A.
2) You can adjust the temperature with a range of 15℃-35℃; the timer with the
time range of 0h-24h; the power can be adjust between high and low heat.
3) Power on the mechanical switch on one side. Once a “bip” is heard, the current
ambient temperature shall appear on the display panel.
5. Operation:
◼ Press the “MODO” (mode) key once, the timing symbol will appear on
the display, you can adjust the timer by pressing (“+” or “—”) key within the
range of 0h-24h. If you don’t press any key during 10 seconds, on the display
will appear the ambient temperature. Press the “MODO” (mode) key twice and
the temperature symbol will appear on the display, you can adjust the
temperature by pressing (“+” or “—”) key, the temperature can be adjusted
within the range of 15℃-35℃. After de adjustment press the “MODO” (mode)
key again to activate de selection, if you don’t press any key in 10 seconds, the
immediate ambient temperature will appear on the display.
◼ Press key, the heat operating symbol will appear on the display,
which means the machine is operating under low heat status. When pressing
key again, the machine stops heating.
◼ Press “Potencia” (power) key, the symbols of low heat position and high
heat position shall work alternatively. Under low heat operating status, the
low heat indicator is on and the indicator lights on each side of the display
panel flicker with the upper part being red; under high heat operating status,
both symbols of low heat position and high heat position shall be on,
when the indicator lights on each side of the display panel flicker with the
middle part being yellow and the upper and lower pars being red.
◼ When the machine is under heating status, press “Modo” (mode) key, to adjust
the timer or the temperature.
◼ Press the key only the temperature sigh and the current ambient
temperature are left on the display panel, when the machine stops heating and
is in idle status.
-13-