EN_IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.

FR_IMPORTANT:A LIRE ATTENTIVEMENT ET À CONSERVER POUR CONSULTATION

ULTÉRIEURE.

ES_IMPORTANTE, LEA Y GUARDE PARA FUTURAS REFERENCIAS.

DE_WICHTIG! SORGFÄLTIG LESEN UND FÜR SPÄTER NACHSCHLAGEN AUFBEWAHREN.

IT _ IMPORTANTE! CONSERVARE IL PRESENTE MANUALE PER FUTURO RIFERIMENTO E

LEGGERLO ATTENTAMENTE. US_CA

IN220900743V01_US_CA

INdac005_US_CA_D00-144_D00-144V01

when the cycle

is to be used on public roads (e.g.lighting and reflector)

PRE-RIDE SAFETY CHECK

in good physical condition.On the negative influence of the trailer on the braking

distance of the cycle When the trailer is attached.

D. flag ×1

E. rear wheel ×2

MAIN FRAME AND SIDE PANEL ASSEMBLY

Remove the trailer and all components from carton. While the trailer is still in folded

position, lift both side panels to an upright position.

Place the cross bar into the plastic cross bar catch at the bottom of the side panel.

Be sure to line up the holes in the crossbar with the holes in the catch to allow the

spring clip to be installed. Insert spring chip that is on the strap attached to the side

panel. Lock safety pin as shown in the illustrations below.

The trailer provides one inner D-rings for safety retain.

INSTALLING AND REMOVING WHEELS

Place the wheel hub on the axle by simply pushing in the wheel until it snaps in

place, so the wheel cannot be removed. Push in all the way so that the wheel

cannot be pushed further. After both wheels are assembled/attached pull on the

wheels to ensure they cannot be removed.

To remove the wheels, lift back of trailer up and simply push on the push buttons

located on the axle and remove the wheels.

NOTE: Check tire sidewall for proper tires inflation and check tires regularly.

MAKE SURE TO ALWAYS USE THE SAFETY FLAG TO MAXIMIZE YOUR VISIBILITY TO OTHER

VEHICLES SHARING THE ROAD OR PATH.

NOTE: Ensure the safety pin is secured with the spring clip.

INSTALLING PUSH BAR

handle height

INSTALLING FRONT WHEEL

Remove the hitch arm , Insert the front wheel into the front casing with the spring

clip and lock the latch。

How to habituate your dog to the trailer

Please take enough time and choose a quiet place So that you can train your dog

without any disturbances, which might get him distracted or alarmed. Furthermore,

it is important to choose an even surface, like an asphalted surface. The dog should

wear a harness. The rear door should be opened while the front door should be

closed. If possible take a second person to assist.

To accustom the dog to the bicycle trailer, the training will be ideally carried out in 3

steps:

Step 1: The dog becomes acquainted with the bicycle trailer.

1. An assistant will safely hold the bike with the trailer during the entire training, and

avoid wagging the trailer back and forth when riding. Lead your dog through the

rear door inside the trailer and secure him with the short lead.

2. Close the rear door and open the front door. Praise the dog properly and give him

a treat.

front door.

3. When the dog sits still, the assistant slowly starts riding the bike with the trailer.

Walk alongside the trailer and praise your dog properly.

- If the dog becomes anxious, stop the trailer. As soon as the dog has calmed down,

reward your dog with a treat and stop the training as in Step 1.

Step 3: Riding with bike and trailer

1. The assistant again safely holds the bike and trailer while you guide the dog into

the trailer and attach the short lead to the dog's harness.

2. Close the rear door and reward your dog by giving him a treat through the front

door.

minutes.

If the dog stays calm, you can extend the ride time step-by-step and cycle without

an assistant. Repeat Step 3 as necessary until your dog gets used to riding in the

trailer.

CASQUES DE VELO HOMOLOGUE