Cobra MicroTalk PR 1101 WX Instrucciones de operación
- Categoría
- Cargadores de dispositivos móviles
- Tipo
- Instrucciones de operación
Insert round connector
of 110 volt adapter.
Plug 110 volt adapter
into electrical outlet.
The CHARGE indicators
light will stay on
STEADY as long as the
radio or battery pack is
being charged.
Once the radio or battery
pack has been fully charged,
the CHARGE indicator light
will blink on and off. It
normally takes about 2 1/2
hours to fully recharge
batteries.Batteries will not be
damaged if they stay in the
charging well longer than
that. The charger is self-
adjusting and will not
overcharge the batteries.
FA-CK
Desktop
Rapid Charger
English
Instructions
1
2
3
For use with Cobra®
microTALK® models
PR 951 DX or PR 1101 WX.
Each port can charge one
radio or one NiMH battery
pack model FA-BP.
Uses 110 Volt adapter
indoors.
Note
If you put your batteries in
the wrong way, the CHARGE
light will not turn on.
Important
Use only Cobra® Nickel Metal
Hydride Battery Pack (NiMH),
model FA-BP with charger
model FA-CK.
For charging Cobra®’s
microTALK® radio:
Take cavity insert out of the
desktop charger and insert
radio. If charging light is not on,
check position of radio. Radio
should be upright.
For charging batteries:
With the arrow on the battery
pointing up, place battery inside
cavity so contacts are touching
the back outside wall.
FOR PRODUCTS PURCHASED IN THE U.S.
COBRA® ELECTRONICS CORPORATION warrants that its COBRA® FA-CK Battery Charger, and the component
parts thereof, will be free of defects in workmanship and materials for period of one (1) year from the date of
first consumer purchase. This warranty may be enforced by the first consumer purchaser, provided that the
product is utilized within the U.S.
COBRA® will, without charge, repair or replace, at its option, defective FA-CK battery chargers, products or
component parts upon delivery to the COBRA® Factory Service Department, accompanied by proof of the date
of first consumer purchase, such as a duplicated copy of a sales receipt.
You must pay any initial shipping charges required to ship the product for warranty service, but the return
charges will be at Cobra®'s expense, if the product is repaired or replaced under warranty.
Exclusions: This limited warranty does not apply; 1) to any product damaged by accident; 2) in the event of
misuse or abuse of the product or as a result of unauthorized alterations or repairs; 3) if the serial number
has been altered, defaced or removed; 4) if the owner of the product resides outside the U.S.
All implied warranties, including warranties of merchantability and fitness for a particular purpose are
limited in duration to the length of this warranty. COBRA® shall not be liable for any incidental,
consequential or other damages; including, without limitation, damages resulting from loss of use or
cost of installation.
Some states do not allow limitations on how long an implied warranty lasts and/or do not allow the
exclusion or limitation of incidental or consequential damages, so the above limitations may not apply
to you.
Customer Assistance
(773) 889-3087 8:00 am–6:00 pm CST, Weekdays (Except holidays)
Technical assistance is also available on-line at
www.cobra.com or by e-mail at [email protected]
Limited One Year Warranty ENGLISH
Cargador
rápido de
escritorio
FA-CK
Español
Instrucciones
1
2
Para utilizarse con los
transmisores-receptores
Cobra® microTALK® modelos
PR 951 DX o PR 1101 WX.
Cada receptáculo de carga
puede cargar un radio o un
paquete de pilas NiMH
Cobra® modelo FA-BP.
Utiliza un adaptador de
110 V para uso bajo techo.
Nota
El indicador de CARGA no se
ilumina si coloca las pilas en
posición incorrecta.
Importante
Utilice únicamente el
paquete de pilas de níquel-
hidruro metálico (NiMH)
Cobra® modelo FA-BP con el
cargador modelo FA-CK.
Para cargar el radio Cobra®
microTALK®:
Quite la tapa de la cavidad del
cargador de escritorio y coloque
el radio en la cavidad. Revise la
posición del radio si el indicador
de carga no se ilumina. El radio
debe estar en posición vertical.
Para cargar el paquete de pilas:
Con la flecha del paquete de pilas
apuntando hacia arriba, coloque
el paquete de pilas en la cavidad
de manera que los contactos
toquen la pared posterior.
3
Inserte el conector
redondo del adaptador
de 110 V o del adaptador
para encendedor de
cigarrillos en el
receptáculo de la parte
trasera del cargador.
Conecte el adaptador de
110 V a la toma eléctrica
o introduzca el
adaptador para
encendedor de cigarrillos
en el encendedor de
cigarrillos del vehículo.
Los indicadores de
CARGA se mantienen
iluminados,SIN
PARPADEAR, mientras se
está cargando el radio o
el paquete de pilas.
El indicador de carga
comienza a parpadear una
vez que el radio o el paquete
de pilas está completamente
cargado.Normalmente se
requieren 2 horas y media
para cargar las pilas por
completo.Las pilas no se
dañarán si permanecen más
tiempo en la cavidad de
carga. El cargador se ajusta
en forma automática y no
carga las pilas excesivamente.
Garantía ESPAÑOL
Cobra
®
Electronics
Corporation
6500 West Cortland Street
Chicago, Illinois 60707 USA
Comuníquese con su
distribuidor local de
Cobra® Electronics
para obtener
información sobre la
garantía.
-
1
-
2
-
3
-
4
Cobra MicroTalk PR 1101 WX Instrucciones de operación
- Categoría
- Cargadores de dispositivos móviles
- Tipo
- Instrucciones de operación
En otros idiomas
Documentos relacionados
-
Cobra Electronics FRS235 Manual de usuario
-
-
-
-
-
-