For use with nominal 2x4 rails in the vertical position:

1. Measure the distance between two posts and subtract 1/2”. Cut rails to this length.

2. Attach a connector to each end of the rail with two screws through the pre-drilled holes (fig. 1).

Set the rail at the desired height and check to ensure it is level. Fasten with screws through the

pre-drilled holes (fig. 2).

3. To ensure the connectors stay in place, apply a small amount of clear silicon on the screw being inserted

into the connector.

Pour utilisation avec une rampe de 2 po sur 4 po, installée à la verticale :

1. Mesurer la distance entre deux poteaux et en soustraire 1/2 po. Couper la rampe à la longueur voulue.

1. Mida la distancia entre dos postes y réstele 1/2”. Corte los barandales a esta longitud.

2. Coloque un conector a cada extremo del barandal usando los tornillos y las perforaciones ya

taladradas (fig. 1). Ajuste el barandal a la altura deseada y verifique que esté nivelado. Ajústelo en

su lugar con los tornillos en las perforaciones ya taladradas (fig. 2).

3. Para asegurarse de que los conectores permanezcan en su lugar, aplique un poco de silicona

transparente en el tornillo que vaya a insertar en el conector.

The diagrams and instructions in this brochure are for illustration purposes only and are not meant to replace a licensed professional. Any construction or use of the product must be in

accordance with all local zoning and/or building codes. The consumer assumes all risks and liability associated with the construction or use of this product. The consumer or contractor

should take all necessary steps to ensure the safety of everyone involved in the project, including, but not limited to, wearing the appropriate safety equipment. EXCEPT AS CONTAINED

IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES NOT PROVIDE ANY OTHER WARRANTY, EITHER EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY DAMAGES,