38
Your appliance complies with the
European directives and their
amendments.
ENERGY-SAVING MEASURES
In order to reduce the power
consumption of your appliance:
• Install it in a suitable location
(see "Installing your appliance").
• Leave the doors open for the
shortest time possible.
• Never put hot food in the
fridge or the freezer, and in
particular soups and other
preparations that release a lot of
steam.
• Check that your appliance is
working correctly and do not
allow too much ice to
accumulate in the freezer
(defrost when the ice is more
than 5-6 mm thick). Clean the
condenser on a regular basis
(see chapter "Routine
maintenance of your
appliance").
• Regularly check the door seals
and make sure that the doors
can be closed properly. If this is
not the case, contact after-sales
service.
• Do not adjust the temperature
too low.
• Failure to install the draws,bins
and shelves properly can result
in increased power consumption.
Warning
If your transported the appliance
horizontally, position it vertically
and wait for 2 hours before
connecting it. A little oil may flow
into thecooling circuit. Allow
enough time for the oil to return
to the motor before connecting
the appliance, failing which, it
could be
Always unplug your appliance
before any maintenance work.
Never pull on the power cord, but
only on the plug itself.
CLEANING AND
MAINTENANCE
Always switch off the
appliance before any
maintenance operations.
Never clean the appliance
with metal objects, steam
systems, volatile oils, organic
solvents or abrasive
components.
Do not use sharp or cutting
objects
to remove the ice. Use a plastic
sponge.
Refer to the
"Maintenance" chapter in this
manual to replace the light
bulb.
WARNING! Please
keep the product far
away fire source during
using, service and disposal.
There are flammable materials at
the back of the appliance. Pay
attention to the symbol “Risk of
fire – flammable material” which
is located on rear of the
appliance.