21 EN
Useful information
C
Troubleshooting
IMPORTANT:
Before troubleshooting, disconnect the power supply. Only
a qualified electrician of competent person must do the
troubleshooting that is not in this manual.
There are some sounds during normal use (compressor,
refrigerant circulation).
Problem Possible cause Solution
Appliance does not
work
Mains plug is not plugged in or is
loose Insert mains plug.
Fuse has blown or is defective Check fuse replace if necessary.
Socket is defective Mains malfunctions are to be
corrected by an electrician.
Appliance cools too
much
Temperature is set too cold or the
appliance runs at Super modes.
Turn the temperature regulator to a
warmer setting temporarily.
The food is too warm.
Temperature is not properly
adjusted.
Please look in the initial
Temperature Setting section.
Door was open for an extended
period.
Open the door only as long as
necessary.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
Turn the temperature regulation to
a colder setting temporarily.
The appliance is near a heat source. Please look in the installation
location section.
Unusual noises
Appliance is not level. Re-adjust the feet.
The appliance is touching the wall
or other objects. Move the appliance slightly.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or the
wall.
If necessary, carefully bend the
component out of the way.
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here,
refer to the rating plate.