If you plan on holding a large cylinder with the base
unsupported, it is advisable to use a piece of angle
iron, wood block or shelf bracket at the bottom of the
cylinder. This will prevent slippage (especially on a
vehicle) and will also make it easier to lock the clamp
in place.
#544
INSTRUCTIONS
See separate document for standard size Quick Fist (#540) instructions.
Super Quick Fist™ is a one-piece rubber clamp that
mounts easily to keep equipment firmly in place. Ideal for
holding fire extinguishers, oxygen cylinders, CO2 tanks, and
other equipment. Use on boats, off-road trucks, military
equipment, ATVs or any vehicle. Can also be installed in
structures such as storage sheds.
Quick Fist clamps are made of heavy duty transportation
grade rubber. They’re UV resistant and withstand
extreme heat or cold. Ideal for marine use,
since Quick Fist will not rust or corrode.
Mounts easily with three #10 (5 mm) bolts
or screws (not included).
To Install:
Super Quick Fist can be mounted with the strap fac-
ing in any direction. Use three #10 bolts or screws to
fasten. Do not over tighten.
After mounting Super Quick Fist, stretch the strap by
putting one hand on the base and using the other to
pull in a perpendicular direction several times on the
strap.
#544 Super Quick Fist
For mounting smaller
equipment or tools,
use standard size Quick Fist
(#540)
• Holds objects from 21/2–71/2" in diameter
(64–191 mm)
• Each clamp supports approximately 50 lbs.
(23 kg)
• Mounting base measures 7/8 x 6"
(22 x 152 mm)