1

Mobile Air Circulators

®

Installation, Operation and Maintenance Manual

Please read and save these instructions for future reference. Read carefully before attempting to assemble,

install, operate or maintain the product described. Protect yourself and others by observing all safety

information. Failure to comply with these instructions will result in voiding of the product warranty and may

result in personal injury and/or property damage.

Document 474538

different mounting accessories:

ceiling mount bracket, wall mount kit,

1. Read and follow all instructions, cautionary

markings and make sure power source conforms

to the requirement of the equipment.

Replace worn or damaged cord immediately.

4. In critical applications, use a suitable alarm (air

switch, temperature sensor, etc.) should the fan

malfunction.

Model MAC

Designed to move high volumes of

directed airflow at low velocity,

keeping individuals comfortable

and productive in factories and

warehouses. Galvanized steel

factory wired, 3-conductor cord with

General Safety Information

WARNING

To reduce the risk of fire, electrical shock, or injury

to persons, observe the following:

a. Use this unit only in the manner intended by the

manufacturer. If you have questions, contact the

manufacturer.

b. Before servicing or cleaning unit, switch

power off at service panel and lock the service

Do not depend on any switch to disconnect power

supply. Always unplug the power cord or turn off

and lock disconnecting means as described.

DANGER

Do not place body parts or objects in circulator or

motor openings while motor is connected to the

power source.

WARNING

To reduce the risk of fire or electrical shock, do

not use this fan with any solid-state speed control

WARNING

flammable, explosive, chemical-laden, or wet or

rainy atmospheres. Use special purpose circulators

designed for particular application. Do not attach

ductwork to a circulator.

2

Mobile Air Circulators

Receiving

Upon receiving the product, check to ensure all

lading which is countersigned by the delivering carrier.

If damaged, immediately contact your Greenheck

Representative. Any physical damage to the unit after

acceptance is not the responsibility of Greenheck Fan

Corporation.

Unpacking

Verify that all required parts and the correct quantity

of each item have been received. If any items are

missing, report shortages to your local representative

to arrange for obtaining missing parts. Sometimes it

or chipping the coating. Damaged finish may reduce

ability of fan to resist corrosion.

Storage

Fans are protected against damage during shipment.

If the unit cannot be installed and operated

immediately, precautions need to be taken to prevent

deterioration of the unit during storage. The user

assumes responsibility of the fan and accessories

while in storage. The manufacturer will not be

responsible for damage during storage. These

blowing dust, rain or snow. Temperatures should be

evenly maintained between 30° to 110°F (-1° to 43°C),

wide temperature swings may cause condensation

and “sweating” of metal parts. All accessories must

be stored indoors in a clean, dry atmosphere.

The unit should be stored at least 3½ inches (89 mm)

off the floor on wooden blocks covered with moisture

proof paper or polyethylene sheathing. Aisles between

parts and along all walls should be provided to permit

air circulation and space for inspection.

inspection, rotate the propeller by hand ten to fifteen

revolutions to distribute lubricant on motor.

Removing From Storage

As fans are removed from storage to be installed

in their final location, they should be protected and

maintained in a similar fashion until the fan equipment

goes into operation.

Prior to fully assembling and installing the fan inspect

the fan assembly to make sure it is in working order.

1. Check all fasteners, set screws on the fan,

1. The 2-speed, 115V motors operate by flipping the

switch: High-Off-Low.

2. Keep circulator head free from obstructions.

Maintenance

WARNING

To reduce the risk of injury, disconnect and lockout

power source before servicing. Always unplug the

power cord.

WARNING

If the electrical cord is damaged, it must be replaced

When replacing belt, use same type that was

supplied with unit.

3. Follow motor manufacturer’s instructions for

motor lubrication.

4. Check for unusual noises when circulator is

running.

5. Periodically inspect and tighten all bolts.

cause cords to break, leading to premature belt

failure.

Our Commitment

474538 • Circuladores de Aire Móviles • Mod. 3 de marzo, 2019 Copyright 2019 © Greenheck Fan

Valorizando el Aire.

Saltillo, México • [email protected] • greenheck.com.mx

EE.UU. • Teléfono: 715.359.6171 • Fax: 715.355.2399 • Partes: 800.355.5354 • Correo electrónico: [email protected] • Sitio web: www.greenheck.com

Como resultado de nuestra comisión de mejora continua, Greenheck reserva el derecho de cambiar

especificaciones sin aviso.

com ubicadas en la pestaña nominada Library, bajo Garantias.

4

Circuladores de Aire Móviles

PRECAUCIÓN

Funcionamiento

PRECAUCIÓN

ADVERTENCIA

Mantenimiento

Recepción

Desembalaje

Almacenamiento

Retiro del Almacenamiento

1

ADVERTENCIA

ADVERTENCIA

ADVERTENCIA

Información de Seguridad General