cooktop heat for a variety of cookware. The center oval burner delivers heat

evenly over a large area, and provides the optimum temperatures for griddle

cooking.

The Samsung gas oven range combines all the benets of 3 separate home

appliances - a gas range, a gas oven, and a storage drawer - to maximize customer

convenience with its careful, stylish design.

To reduce the risk of re, electric shock, personal injuries, and/or death, observe

the following precautions.

• Close the valve and do not use the range.

• Do not light a match, candle, or cigarette.

• Do not turn on any gas or electric appliances.

• Do not touch any electrical switches or plug a

• Do not use any phone in your building.

• Leak testing of the appliance must be conducted according to the manufacturer’s

To reduce the risk of re, electric shock, personal injuries, and/or death, observe

the following precautions.

power outlet in any way.

• Do not put a fuse in a neutral or ground circuit.

• Use a dedicated 120-volt, 60-Hz, 20-amp, AC electrical circuit with a time-delay

fuse or circuit breaker for this range. Do not plug more than one appliance into

The plug must be rmly plugged into an outlet that is properly installed and

grounded in accordance with the local codes and ordinances. If you are unsure

whether your electrical outlet is properly grounded, have it checked by a licensed

electrician.

• The range is supplied with a 3-pronged grounded plug. This cord must be

plugged into a mating, grounded 3-prong outlet that meets all local codes and

ordinances. If codes permit the use of a separate ground wire, we recommend

that a qualied electrician determine the proper path for this ground wire.

• Electrical service to the range must conform to local codes. Barring local codes,

it should meet the latest ANSI/NFPA No. 70 – Latest Revision (for the U.S.) or the

indicators are located above each knob

and show which burner the knob controls.

Each burner is designed for specic cooking

purposes. See the table below.

Make sure all surface burners are properly

installed. To light a burner:

1. Push in the control knob, and then turn

If there is a power failure, you can ignite the burner manually. Use caution when

doing this.

1. Hold a long gas grill lighter to the surface burner you want to light.

2. Push in the control knob for that burner, and then turn it to the Lite position.

Turn on the grill lighter to ignite the burner.

3. After the burner is lit, turn the control knob to adjust the ame level.

The ames on the burners should always stay under the cookware, and should not

extend beyond the cookware bottom at any time.

surface burner controls should be turned OFF when you are not cooking.

• Always turn the burners off before you go to sleep or go out.

• If you smell gas, turn off the gas to the range and call a qualied service

technician. NEVER use an open ame to locate a leak.

• Flat bottom and straight sides

• Tight-tting lid

• Well-balanced with the handle weighing less than the main portion of the pot or

• Cast-Iron: A poor conductor but retains heat very well.

• Enamelware: Heating characteristics depend on the base material.

• Glass: A slow heat conductor. Use only glass cookware that is specied for range

• Do not place a small pan or pot with a

bottom diameter of about 6 inches or less

on the center grate. This cookware may tip

over. Use the rear burners for this small-

Pancakes 5-10 min. MED-HI MED

Hamburgers 5-10 min. HI HI

Fried Eggs 5-10 min. HI MED-HI

Bacon 5-10 min. HI HI

Breakfast Sausages 5-10 min. HI HI

• Do not remove the griddle until the cooktop grates, surfaces, and griddle itself

cool down.

• If you leave the griddle on the cooktop, it may become very hot when you use

• You may need to adjust heat settings for the griddle over time.

• The griddle may discolor over time as it becomes seasoned with use.

• Do not let rust remain on the griddle. If rust appears on the griddle, remove it as

soon as possible.

Put all ingredients in a heat-safe container.

Select a cooking mode, and then start

• The cooling fan automatically runs for a certain amount of time after cooking is

• There can be slight popping sound during oven cooking. This sound may occur

• Make sure to close the door before you

start cooking.

• If you leave the door open for 20-30 seconds

3. Press the START/SET pad.

• The oven preheats until it reaches the temperature you set.

• It beeps six times when the temperature reaches you set.

• When preheating is complete, place the food in the oven, and then close the

door.

4. When cooking is complete, press the OFF/CLEAR pad, and then take out the

food.

To change the temperature during cooking, repeat steps 1 through 3 above.

The convection fan at the back of the oven

circulates hot air evenly throughout the

oven cavity so that food is evenly cooked

and browned in less time than with regular

heat.

When using convection cooking, always pre-heat the oven for the best results.

Convection baking • Ideal for foods being cooked using multiple racks.

• Good for large quantities of food.

• Provides the best performance for cookies, biscuits,

• This is for reference only.

Make sure to close the door after turning over the food.

Your oven range comes with 2 racks and 7 rack positions. The rack positions are

delineated by rack guides which support the racks. Each rack guide has a stop

that prevents the rack from loosening during the oven's operation. Each rack has

stoppers that need to be placed correctly on the rack guides. The stoppers prevent

Broiling hamburgers 6

Broiling meats or small

cuts of poultry, sh

5-4

Bundt cakes, Pound

cakes, Frozen pies,

casseroles

4 or 3

Fresh Pizza, Angel

• Do not cover an oven rack with aluminum foil. This will hamper heat circulation,

• Do not place aluminum foil on the oven bottom. The aluminum can melt and

• Arrange the oven racks only when the oven is cool.

• When placing an oven rack in the top-most rack position (position 7), make sure

• The Oven Rack Settings table is for reference only.

• We recommend cooking pizza and pies using the 2nd rack position for crispy

bottoms.

1. Place the rear end of the rack on a rack

remove it from the rack guide.

or

Centering the baking pans in the oven

as much as possible will produce better

results. If baking with more than one pan,

place the pans so each has at least 1˝ to

1½˝ of air space around it.

gure on the left.

When baking cakes and cookies on multiple

racks, place the oven racks in positions 3

and 5. See the gure on the left.

they should not stand for more than 1 hour before cooking begins and should be

removed promptly when cooking is completed.

1. Press the pad corresponding to a desired cooking mode such as Bake.

2. If necessary, change the temperature using the number pad.

3. Press the Cooking Time pad.

4. Set the cooking time between 1 minute and 9 hours and 59 minutes (9:59) using

the number pad.

5. Press the START/SET pad. The oven will automatically turn on and start

1. Download and open the Samsung Smart Home app on your smart device.

2. Follow the app's on-screen instructions to connect your range.

3. Once the process is complete, the connected icon located on your range

displays and the app will conrm you are connected.

4. If the connection icon does not turn on, follow the instruction on the app to

reconnect.

1. Press Smart Control. appears in the display. The oven can now be controlled

remotely with a connected remote device.

2. Select the oven icon on the Samsung Smart Home app to open the Oven Control

app. When the app is connected to the oven, you can perform the following

functions through the application:

• Turn the oven off remotely.

time and temperature remotely.

Error Check • Automatically recognize errors.

Temp Probe

• Monitor the current temperature and reset the

probe setting.

• If is not shown in the display, you are still able to monitor the oven and

cooktop status and turn the oven off.

2. Press 0 on the number pad to select on or off.

3. Press the START/SET pad to save the changes.

• Opening the oven door or pressing Smart Control will delete from the display

and prevent most of the remote functions from operating.

• When oven cooking is nished or cancelled, is removed from the display.

• For safety reasons, you cannot turn on the gas oven remotely.

• For safety reasons, you must specify the cooking time to enable remote control.

• The oven continues operating even if the Wi-Fi connection is lost.

• Smart Control will not work properly if the Wi-Fi Connection is unstable.

and the door.

2. Clean the control panel using a soft cloth dampened with plain water, warm

soapy water, or glass cleaner. Do not spray cleansers directly onto the control

panel.

3. When done, press and hold the START/SET pad again for 3 seconds.

• Make sure the control panel turns off and all surfaces of the range are cool

• If the range has been moved away from the wall, make sure the anti-tip device is

3. Clean one small area at a time, rubbing with the grain of the stainless steel if

applicable.

4. When done, dry the surface using a soft, dry cloth.

5. Repeat steps 2 through 4 as many times as necessary.

• Do not use a steel-wool pad or abrasive cleanser on stainless steel surfaces. It

• Do not spray any type of cleanser into the manifold holes. The ignition system is

To keep the racks clean, remove them from the cavity, and soak them in lukewarm

soapy water. Then, scour soil off of the racks using a plastic scouring pad. If the

rail guides with wax paper or a cloth containing a few drops of cooking oil. This

will help the racks glide more easily on their tracks.

• For online shopping, visit http://www.samsungparts.com/Default.aspx and search

for part DG81-01629A.

• Do not leave the racks in the oven during the self-cleaning cycle. The extreme

heat generated in this cycle can permanently peel off the rack coating and make

it difcult to slide the racks on the guide rails.

• Do not spray cooking oil or lubricant directly onto the racks.

Do not remove the inner gasket of the oven door for cleaning.

Do not let moisture enter the door or

contact the door gasket. Moisture may

reduce the gasket’s performance.

Make sure all surface burner knobs are in the OFF position.

1. Pull knobs off the control valve stems.

2. Clean the knobs in warm, soapy water.

3. Clean the stainless steel surfaces using

The porcelain-enameled cooktop surface needs to be kept clean. We recommend

that you remove food spills immediately after they take place.

1. Turn off all surface burners.

and then remove them.

3. Clean the cooktop surface using a soft

cloth. If food spills run into gaps of the

burner components, remove the burner

cap and the head, and wipe up the spills.

4. When cleaning is nished, reinsert the

burner components, and then put the

burner grates back into position.

• Do not use a steel-wool pad or abrasive cleaner, which can scratch or damage the

enamel surface.

Turn off all surface burners and make sure they have all cooled down.

1. Remove the burner grates.

2. Remove the burner caps from the burner

3. Remove the burner heads from the

4. Clean all removable grates and burner

5. Rinse and dry grates and burner

• After cleaning, conrm that the burner port openings aren't plugged.

• Do not wash any burner components in a dish washer.

correct burner head, is centered on the

This self-cleaning oven uses high temperatures (well above cooking temperatures)

to burn off leftover grease and residue completely or reduce them to a nely

• Do not force the oven door open during the self-cleaning cycle. This will damage

the automatic door-locking system. The door automatically locks when the self-

Make sure all surface burners are off while

the oven is performing a self cleaning

cycle. Self-clean will not operate if a surface

time.

You may nd it necessary to stop or interrupt a self-cleaning cycle due to smoke

in the oven. To turn off the self-cleaning cycle, press the OFF/CLEAR pad. The

cycle turns off, but the door remains locked and the Lock icon blinks until the oven

temperature falls below 400 °F (204 °C).

steam could burn you.

The oven light is a standard 40-watt appliance bulb. It comes on when you open

the oven door.

by turning it counterclockwise.

5. Insert a new 40-watt appliance bulb into

the socket, and then turn it clockwise to

tighten.

6. Reinsert the glass cover, and then turn it

clockwise to tighten.

To prevent electric shock, make sure the oven is turned off and cool before

replacing the oven light.

• Turn the power OFF before removing the door.

1. Open the door completely.

2. Pull the hinge locks down toward the door frame to the unlocked position.

1. Firmly grasp both sides of the door at the top.

2. With the door at the same angle as the removal position, slide the indentations

hinge arm must be fully inserted into the bottoms of each slot.

Bottom edge of slot

3. Open the door fully. If the door will not open fully, the indentations are not

inserted correctly in the bottom edges of each slot.

Storage drawer

1. Slide open the drawer until it stops.

2. Locate the roller guide clips on either

side. Using both hands, pull down the left

clip while lifting the right clip, and then

remove the drawer.

3. Clean the drawer in warm, soapy water

using a cloth or soft brush. Then, rinse

and dry it thoroughly.

4. Put the drawer in the roller guides on

You smell gas. The surface burner knob is

not in the OFF position and

the burner is not lit.

Turn the burner knob to OFF

There is a gas leak. Clear the room, building, or

area of all occupants.

Immediately call your gas

supplier from a neighbor’s

phone. Do not call from your

department.

All burners do not

light.

The power cord is

not plugged into the

electrical outlet.

Make sure the electrical plug

is plugged into a live, properly

grounded outlet.

A fuse in your home

may be blown or the

circuit breaker may have

tripped.

Replace the fuse or reset the

circuit breaker.

The gas supply is not

See the Installation

The burner base is

misaligned.

burner head.

Align the burner base.

Surface burner

clicks during

operation.

The control knob has

been left in the Lite

position.

After the burner lights, turn

the control knob to a desired

setting.

a service technician.

The burners do not

burn evenly.

Surface burner

components and caps are

not assembled correctly

See page 35.

The following URL http://opensource.samsung.com/opensource/SimpleConnectTP/

seq/0 leads to the download page of the source code made available and open

source license information as related to this product. This offer is valid to anyone

in receipt of this information.

Please be advised that the Samsung warranty does NOT cover service calls to explain product operation, correct improper installation, or perform normal cleaning or

maintenance.

QUESTIONS OR COMMENTS?

Scan the QR code* or visit

www.samsung.com/spsn

to view our helpful

How-to Videos and Live Shows