Rev-A-Shelf 448-SR8-1 Instrucciones de operación

Tipo
Instrucciones de operación

Este manual también es adecuado para

448 Series Pull-Out Wood Spice Rack Instruction Sheet
Instrucciónes para la Serie 448
Cajones de Madera con Compartimientos para Especias
Instructions Du bois De Support D’Épice De 448 Séries
1. Disengage Cabinet Slide Assembly from unit
by pressing release levers on the 2 vertical slides
and pulling unit away from Cabinet Slide
Assembly. (Fig 1)
2. Insert spice rack at angle as shown. (Fig. 2)
Note: Shelf may need to be adjusted lower to
allow spice rack and spices to clear opening of
cabinet.
1. Dégager I’ensemble de glissières de l’armoire
de la base coulissante en
appuy ant sur les leviers de dégagement
des deux glissières verticales et en retirant
la base de l’ensemble de glissières. (Fig. 1)
2. Inserte el ángulo del compartimiento de
especias como se indica. (Fig. 2) Nota:
El estante podrá necesitar un ajuste
más bajo para permitir que el compartimiento
de especias y las especias entren
adecuadamente en el gabinete.
1. Presione la palanca de desenganche en
cada una de las dos deslizaderas verticales
del armario para desarticular el ensamblaje
y sacarlo del armario. (Fig. 1)
2. Insèrez le support d’èpice à l’angle comme
montrè. Note: Lètagère peut devoir être
abaissèe pour permettre le support et les
èpices à l’ouverture claire du coret. (Fig. 2)
I-448SR
03/08
Fig. 2
Fig. 1
Installation Instructions for:
RV-Series
Pull-Out Waste Containers and Hampers
With the frame in a closed position, insert the front two
screws, making sure that the framework is square to the
front of the cabinet.
If there is suf cient clearance, install rear screws.
If framework prevents access to rear screws, remove
framework by pulling out and lifting frame from slides.
remove frame by disengaging release triggers (Fig. A).
Finally, place your waste container in the wire frame and the
installation is complete.
Your RV series has been shipped fully assembled for ease
of installation.
• First Remove the container(s) from the wire frame.
• Place the frame inside of your cabinet.
• Look to make sure that there is plenty of clearance to
shut the door and for the waste container.
I-RV-05
©2005 Rev•A•Shelf, Inc. • 2409 Plantside Drive • Jeffersontown, KY 40299 • 1-800-626-1126 • FAX 502-491-2215
1
2
3
FIGURE A
If you have any questions or would like additional information
on the rest of our prod ucts for the kitchen, closet, or
bathroom, please contact a Customer Service Specialist at:
1-800-626-1126 or visit us on the web at www.rev-a-shelf.com.
Also, don't forget about our door mount kit (RV-DMKIT)
that will attach your current cabinet door to your RV Waste
Container or Hamper.
1
2
3
  • Page 1 1

Rev-A-Shelf 448-SR8-1 Instrucciones de operación

Tipo
Instrucciones de operación
Este manual también es adecuado para

En otros idiomas