1 Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.

modernforms.com

Phone (800) 526.2588

Fax (800) 526.2585

Headquarters/Eastern Distribution Center

44 Harbor Park Drive

Port Washington, NY 11050

Central Distribution Center

1600 Distribution Ct

Lithia Springs, GA 30122

Western Distribution Center

1750 Archibald Avenue

Ontario, CA 91760

INSTALLATION INSTRUCTION

Shadow – Outdoor Sconce

WS-W46817 / WS-W46824

Junction Box Screw

Qty: 2pcs+1 Extra

Qty: 1 Extra

Plastic Anchor

Qty:2pcs+1 Extra

Wood Screw

Qty: 2pcs+1 Extra

- System is intended for installation by a qualied electrician in accordance with the National Electrical Code and local regulations.

- Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or switch ”OFF”

the circuit breaker switch(es) that control the power to the xture or room that you are working on.

- Place the wall switch in the “OFF” position.

CAUTION

- All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are

worn out or broken. Failure to follow this instruction could invalidate the ETL/CETL listing of this xture.

CAUTION When handling the xture, do not apply pressure to the LEDs. Hold the xture by the base only.

AVERTISSEMENT

IMPORTANT : Coupez l’électricité avant TOUTE manipulation.

MISE EN GARDE

- Toutes les pièces doivent être utilisées tel qu’il est indiqué dans ces instructions. Ne remplacez pas les pièces, n’en laissez pas de côté

et ne les utilisez pas si elles sont usées ou brisées. Le non-respect de ces instructions peut annuler l’homologation ETL/CETL du

luminaire. MISE EN GARDE Ors de la manipulation de l’appareil, ne pas appliquer de pression à la LED, tenir l’appareil par la seule base.

ADVERTENCIA

IMPORTANTE: NUNCA intente hacer trabajos sin desconectar el suministro eléctrico.

- Lea y comprenda todas las instrucciones e ilustraciones por completo antes de proceder con el ensamblaje e insta lación de esta

lámpara.

- Sistema está disenado para ser instalado por un electricista calicado, de acuerdo con el código eléctrico nacional y las normas locales.

- Diríjase a la caja de fusibles o a la caja del interruptor de circuito principal en su hogar. Coloque el interruptor de ali mentación

HARDWARE

Qty: 3pcs+1 Extra

2 Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.

modernforms.com

Phone (800) 526.2588

Fax (800) 526.2585

Headquarters/Eastern Distribution Center

44 Harbor Park Drive

Port Washington, NY 11050

Central Distribution Center

1600 Distribution Ct

Lithia Springs, GA 30122

Western Distribution Center

1750 Archibald Avenue

Ontario, CA 91760

INSTALLATION INSTRUCTION

Shadow – Outdoor Sconce

WS-W46817 / WS-W46824

Junction Box Screw

WS-W46817 4 1/4"

7MBC241003 (17")

WS-W46817 9 1/2"

WS-W46824 5 1/4"

7MBC341302 (24")

on a clear area. Be careful not to lose any small parts

necessary for installation.

3. Remove the mounting screw (C) and gasket (D) from the

mounting back plate.

4. Drill holes in the wall aligned with the key hole located in

the mounting plate, insert the plastic anchor (E).

5. Secure the mounting back plate to the junction box using

junction box screws (B), fasten it to the wall using wood

screws (F). The side of the mounting back plate marked

Otherwise, connect the xture’s ground wire directly to the

back plate using the green screw provided. After wires are

connected, tuck them carefully inside the junction box.

7. Secure the xture to the mounting back plate using the

mounting screw (C) and gasket (D).

8. To prevent moisture from entering the outlet box and

causing a short, use clear caulking (i.e. indoor/outdoor

silicone sealant) to outline the outside of xture back plate

where it meets the wall. Leave a space at the bottom to

Fig. 2 Wiring

Junction

Box

Caulking

Fig. 3 Sealing