Westbrass D493244LD-50 Guía de instalación

Tipo
Guía de instalación

Este manual también es adecuado para

4”
12”
3-5/8”
4-1/4”
4”
3-7/16”
2-5/8”
3/16”
Fine Decorative Plumbing Since 1935
WESTBRASS
2429 E. Olympic Blvd.
Los Angeles, CA 90021
REVDWG NO.
DAT E
Sheet 1 of 1
Scale
TITLE
mrohlfs
B
D493244LD
Sch. 40 Linear Drain in PVC
D493244LD 3-20-2015
NTS
D3322-2P
1-1/2” NPSM
PW-12
1-1/2” Sch. 40 PVC
PW-4
1-1/2” Sch. 40 PVC
PW-4
1-1/2” Sch. 40 PVC
529F
1/4” - 20 x 1-3/4”
Flat Head Screw
793W
Tip-Toe
Washer
79338MO
4A-WL
792RW
C
L
793L
Tip Toe
Cap
4B-W
4C-W
793WL
4"
2 3/8"
3/4"
432-COVER
793-SP
D398R
Fine Decorative Plumbing Since 1935
WESTBRASS
Linnear Bathwaste
& Overow
Desbordamiento de Baño Dren
del Lineal
YOU MAY NEED:
USTED PUEDE NECESITAR:
Screwdriver
El destornillador
Tape measure
Cinta métrica
on screws.
Importante: Use cinta para
plomero en las tornillos.
Pliers: For removal and instal-
lation.
Alicates: Para quitar y insta-
lación.
SILCO
N
E
Silicone Sealant: Use Silicone
sealant under base of strainer.
Sellador de silocón: Si el lava-
manos está desnivelado use
sellador de silicón debajo de la
base del borde.
1. Measure and dry t all
connections. Use Hacksaw to
cut pipes as required.
2. Glue ttings using PVC primer
and cement, following the
instructions on the label
3. Place rubber gasket on over-
ow elbow using silicone.
4. Wrap screws with PTFE Tape
and tighten spacer to tub using
screws.
Hacksaw
Sierra
1. Medir y en forma seca todas las
conexiones. Utilizar la sierra para
cortar tubos según sea necesario.
2. Utilice rotula para que coincida
con la parte superior del codo de
la bañera.
3. Coloque la junta de goma en el
codo del rebosadero con silicona.
4. Envuelva tornillos con cinta de
PTFE y apriete espaciador para
tina usando tornillos.
C
L
SILCONE
SILCONE
SILCONE
PVC Primer PVC Cement
Installation Instructions:
Instrucciones de Instalación
Silicone Sealant
Silicone
Silicone Sealant
2429 East Olympic Blvd. • Los Angeles, CA 90021
Finishes:
(01) PVD Polished Brass (26) Polished Chrome (07) Satin Nickel
(12) Oil Rubbed Bronze (50) Powder Coated W (62) Powder Coated Flat Black
CARE & MAINTENANCE
TO CLEAN:
Do not allow your product to come into contact with any cleansers forti-
Soft Scrub, Dawn Liquid Soap, Palmolive or any other combined cleaners
contain certain chemical components that will dissolve and remove the
warm water and mild soap on a soft cloth or sponge. Avoid using any
sponge with a scouring pad to clean your product. It is not necessary to
rub hard to remove spots.
and living, require some care in use.
WARRANTY
a rof detnarraw si stcudorp lla fo ytilanoitcnuf ehT
retaw yna no sevlav csid cimareC .raey one fo doirep
delivery merchandise are warranted for one year. Warran-
ties are guaranteed to the original purchaser only. Product
problems attributable to abuse, misuse, improper instal-
lation, hard water, neglected maintenance or accidental
damage are not covered by this warranty. Modifying the
product in any way voids the warranty. The use of plumb-
ers putty on our products also voids the warranty. Silicone
sealing compounds should be used instead. No repairs
or replacements will be made under
such circumstances
except at customer’s expense. Liability under warranties
expressed or implied is limited to repair or replacement of
defective goods only. In no event will Westbrass be liable for
incidental or consequential damages (such as labor charges).
This warranty does not cover labor charges, whether based on
breach of express or implied warranty, breach of contract,
negligence or any other legal theory.
TO PROTECT:
An occasional application of Carnauba wax
(without cleaners), like that found in Flitz Fau-
cet Wax, Turtle Wax for Clear Coat Car Finishes
or McGuire’s Premium Wax, will enhance the
Functional Warranty:
Other Westbrass nishes, including living nishes and other electroplated nishes carry no warranty.
WESTBRASS 2429 E. Olympic Blvd., Los Angeles, CA 90021
(213)-627-8441 • (213) 627-2844 • or[email protected] • www.westbrass.com
5. Place a thin bead of
silicone seal on bottom of
washer and under strainer.
6. Screw in strainer through
the tub into shoe elbow.
7. Wipe o any excess
silicone with a clean towel
then thread in stopper.
8. Snap on overow cover.
9. Check for leaks.
Silicone seal locations
Lugares de sellado de silicona
Tighten using Pliers or a plug
wrench
Apriete utilizando alicates o una
llave de bujías
5. Coloque un cordón delgado
de la junta de silicona en la parte
inferior de la lavadora y bajo
colador.
6. Atornille el colador de la bañera
en el codo zapato.
7. Limpie el exceso de silicona con
una toalla limpia luego pase en
tapón.
8. Cierre la cubierta de
desbordamiento.
9. Compruebe si hay fugas.
  • Page 1 1
  • Page 2 2

Westbrass D493244LD-50 Guía de instalación

Tipo
Guía de instalación
Este manual también es adecuado para

En otros idiomas