USE INSTRUCTIONS.
- The first thing is to have the machine with the battery charged.
- Prepare the machine adapting the cutting comb that we want to use.
- The hair to be cut must be clean and dry.
- Turn on the machine.
- Cut the hair in the direction against the hair.
- Make several passes to cut long hairs that may escape.
- When the desired result is achieved, turn off the machine.
- For trimming sideburns, remove the trimming comb and trim the sideburns.
- Once its use is finished, clean and store.
WARNINGS.
- The first few times you use the machine, your skin may be slightly irritated. This is normal.
By using the machine regularly, your skin adapts and stops getting irritated.
- The yellow light indicates the lack of oil. When you turn on the machine it flashes 5 times
and it turns off. In case it continues to flash, you should lubricate the blades with the oil.
Note.
Independently of the previous,
the machine must be cleaned and lubricated with its lubricating oil just after each use.
CLEANING AND MAINTENANCE.
- Always clean and grease the machine after each use.
- Never put the machine under the tap or wet it.
- Remove the cutting comb and remove any remaining hair with the cleaning brush.
- Put the machine into operation and pour 2 or 3 drops of lubricating oil on the blade.
- Wait a few seconds for the blades to lubricate and turn off the machine.
- Put the cover of the blades.
- Clean the outside with a soft cloth.
- In case of low battery, also charge the battery before storing.
- Store the machine if possible in its box, in a dry and dust-free area.
SPECIFICATIONS.
- Input voltage for battery charging: 5V.
- Power: 4W.
- 1200mAh battery.
- Charging time: Depends on the amperage of the adapter used.
- Autonomy: Up to 60 minutes.
- Type-C charging connector.
- Display with load percentage.
- 4 cutting combs (1.5mm – 2.0mm – 3.0mm – 4.0mm)
- Charging cable included (Usb to Type-C)
- Compatible adapter that can use: 5VDC and up to a maximum of 2A.