SAFETY INFORMATION
6
• Do not exceed the maximum drawer weight, wood top or total product weight, including contents.
Always balance the loads to avoid tipping. Place the heavier weights on the bottom drawers when
possible.
• Be careful when opening more than one drawer. The product may become unstable and tip,
which may also cause personal injury or product damage.
• Keep the product on level surfaces. The product may become unstable and tip if stored or moved
on an unlevel surface, which may cause personal injury or product damage.
• Secure all items and lock all drawers before rolling this product. Only roll the product short
distances by using the handle provided.
• Two people are needed to safely move this unit.
• Do not store liquids in the unit unless they are secured in an approved container.
• Keep children and bystanders away while loading, unloading, and moving the product.
• Always use common sense and be cautious when using this product. Do not modify this product
in any way.
• Follow all below information for extension cord:
Do not insert extension cord through hole without grommet in place.
Only use a three-wire extension cord with all three prongs intact. Never remove the round
grounding prong.
Extension cord must be connected to a 125Volt GFCI protected outlet with proper ground. If GFCI
outlet is not available, use an extension cord with GFCI protection built in.
Check the insulation and plugs of extension cord before using. Do NOT use cord if it is worn or
damaged.
Do not overload extension cord.
Remove extension cord from the hole before moving or transporting the product.
Do not connect extension cord to outlet that also supplies critical safety equipment with power.
Make sure the power supply cord is unplugged before any servicing or cleaning.
• Follow all below information to avoid electrical shock hazard:
Do not plug cord into outlet with wet hands.
Do not use this product near a bathtub, a shower, or a swimming pool.
Product plugs must match the outlet.
Never modify the plug in any way.
Do not use any adapter plugs with earth (grounded) product power strips.
Unmodified plugs and matching outlets will reduce the risk of electric shock.
Avoid body contact with earthed or grounded surfaces. There is an increased risk of
electric shock if your body is earthed or grounded.
• Refer all below information for FCC rules:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 20 minutes (does not include unpacking time)
Tools Required for Assembly (included): 10 mm Wrench, 14 mm Wrench
Tools Required for Assembly (not included): Adjustable wrench
PREPARATION