A Vanity 1

B Leg 4

C Support Leg 1

Secure the legs (B) in place using washers (BB), lock

washers (CC) and screws (AA), as shown. Tighten with the

hex wrench (DD).

Attach the support leg (C) by screwing it into the center

hole underneath the vanity (A), as shown.

access the leg leveler.

Turn the leveler clockwise to make the leg (B) longer, or

counterclockwise to make it shorter.

Repeat as needed with the other legs (B) or suppport

leg (C) until the vanity (A) stands solidly on the oor.

To protect your bath furniture, we suggest the following:.

Clean up spills immediately. Use a blotting rather than a wiping action. Water left over a long period of time will cause white spots in

Dust frequently with a clean, soft, dry, lint-free cloth. Clean the surface by rubbing in the direction of the grain.

Polish your furniture approximately every six months with a product that contains detergents, emulsiers and mineral oil. The

detergents clean dirt from the furniture; the emulsiers give it body to clean and last longer; the mineral oil is left behind as a barrier

for dirt and moisture that can harm the nish. There is no grit to harm the nish, no wax build-up, and no silicone to raise the sheen

and act as a barrier for touch-ups and renishing.

Clean up spills immediately. Use a blotting rather than a wiping action. Water left over a long period of time will cause white spots in

the nish.

Clean the outside surface with mild soap, warm water, and a soft cloth.

On stubborn stains, use a powdered detergent and damp sponge or nylon scouring pad.