Kichler Lighting 12604WH Manual de usuario
- Tipo
- Manual de usuario
INSTALLATION INSTRUCTIONS
LED Step Light
Models: 12654/CP300482 (dimmable), 12604/CP300388 (non-dimmable)
WARNING: Turn off power.
IMPORTANT: Before you start, NEVER attempt any work without shutting
off the electricity until the work is done.
a) Go to the main fuse or circuit breaker box in your home. Place
the main power switch in the “OFF” position.
b) Unscrew the fuse(s), or switch “OFF” the circuit breaker
switch(s), that control the power to the fixture or room that you
are working in.
NOTES:
electrician is recommended.
electronic low voltage dimmers.
switch box (not supplied).
The box capacity must be 14 cubic inches or larger. Metal or plastic
boxes are acceptable.
INSTALLATION:
mounting, the box may be mounted horizontally or vertically.
2. For optimum light output when wall mounted, the receptacle box
centerline should be 18” above the floor.
receptacle box.
4. For new construction, the drywall or wall surface must be in place and
preferably finished before the fixture can be installed.
connectors provided. These connectors are suitable for solid or stranded
have 1/2” of insulation cleanly removed from the ends. Grip wire firmly
and push each exposed conductor into an available port on each
connector until they are fully inserted. Match insulation color from
branch circuit wires to colors on fixture wires. Join black wire to black,
white to white, and green or bare conductor to green.
6. Verify that each branch circuit wire is fully inserted to the back of the
connector.
8. Place the fixture into the box and secure with the screws provided.
9. Place the trim plate over the fixture and secure with the two screws
provided.
INSTRUCCIONES DE INSTALACIÓN
Luz de escalón del LED Modelos: 12654/CP300482 (c/reductor),
12604/CP300388 (sin reductor)
ADVERTENCIA: Apague la alimentación eléctrica.
IMPORTANTE:
a) Vaya al fusible principal o al cortacircuitos de su casa.
Ponga el interruptor principal de alimentación en
NOTAS:
adecuado para uso exterior.
licenciado.
de cobre.
INSTALACIÓN:
1. En el lugar donde se desee poner el artefacto, monte el tomacorriente.
verticalmente.
2. Para el rendimiento luminoso óptimo, cuando se monte en la pared, el
centro del tomacorriente debe estar 18” arriba del piso.
4. Para una construcción nueva, la pared sin mortero o la superficie de la
pueda instalar el artefacto.
son adecuados para conductores de cobre trenzados o sólidos, desde
coincidir el color del aislamiento de cada alambre del circuito de
derivación con los colores de los alambres del artefacto. Una el
alambre negro al negro, el blanco al blanco y el verde al conductor
verde sin aislamiento.
fondo en la parte posterior del conector.
-
1
Kichler Lighting 12604WH Manual de usuario
- Tipo
- Manual de usuario
En otros idiomas
- English: Kichler Lighting 12604WH User manual
