1
Installation Instructions for
Secure the mounting plate to the junction box.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the set screw using an Allen wrench.
Install the candle tube by sliding it over the socket.
Install the candle follower by placing it on top of candle tube.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information. Repeat steps 6-8 for
remaining sockets.
1
2
3
4
5
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Burdeen Wall
1.0
WB1854-WB1856
W 1854, WB1856B
Wall
1A
JUNCTION BOX
MOUNTING
PLATE
3
ALLEN WRENCH
4
SET SCREW
6
7
CANDLE TUBE
LAMP
SOCKET
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
6
CANDLE FOLLOWER
5
8
7
8