EN - 56
3 USING THE APPLIANCE
3.1 Information on Less Frost
Technology
Thanks to the wrap around evaporator,
Less Frost technology offers more efficient
cooling, less manual defrost requirement,
and more flexible storage room.
3.2 Thermostat Setting
The thermostat automatically regulates the
temperature inside the cooler and freezer
compartments. Refrigerator temperatures
can be obtained by rotating the knob
to higher numbers; 1 to 3, 1 to 5 or SF
(Maximum numbers on the thermostat
depends on your product.)
Super switch
(In some models)Thermostat knob
Lamp cover
(The images are representative)
Thermostat settings:
1 – 2 : For short-term storage of food
3 – 4 : For long-term storage of food
5 : Maximum cooling position. The
appliance will work longer.If required,
change the temperature setting.
If device has SF position:
•Turn the knob to SF to freeze fresh
food quickly. In this position, the freezer
compartment will operate at lower
temperatures. After your food freezes,
turn the thermostat knob to its normal
use position. If you do not change the
SF position, your appliance work will
automatically return to its last used
thermostat position according to the
time indicated in the note. Return the
thermostat switch to the SF position
and return it to normal use according
to the time indicated in the note.If the
thermostat switch is in the SF position
when your appliance is first started, your
appliance work will automatically return
to the operation in the thermostat-3
position according to the time indicated in
the note.
Note: In this appliance, super freeze mode
will automatically cancel after 48 hours.
3.3 Temperature Settings Warnings
•Your appliance is designed to operate in
the ambient temperature ranges stated
in the standards, according to the climate
class stated in the information label. It
is not recommended that your fridge is
operated in the environments which are
outside of the stated temperature ranges.
This will reduce the cooling efficiency of
the appliance.
•Temperature adjustments should be
made according to the frequency of
door openings, the quantity of food kept
inside the appliance and the ambient
temperature in the location of your
appliance.
•When the appliance is first switched on,
allow it to run for 24 hours in order to
reach operating temperature. During this
time, do not open the door and do not
keep a large quantity of food inside.
•A 5 minute delay function is applied
to prevent damage to the compressor
of your appliance when connecting
or disconnecting to mains, or when
an energy breakdown occurs. Your
appliance will begin to operate normally
after 5 minutes.
Climate class and meaning:
T (tropical): This refrigerating appliance
is intended to be used at ambient
temperatures ranging from 16 °C to 43 °C.
ST (subtropical): This refrigerating
appliance is intended to be used at ambient
temperatures ranging from 16 °C to 38 °C.
N (temperate): This refrigerating appliance
is intended to be used at ambient
temperatures ranging from 16 °C to 32 °C.
SN (extended temperate): This
refrigerating appliance is intended to be
used at ambient temperatures ranging from
10 °C to 32 °C.