18
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
Important: Changes or modifications to this product not authorized
could void the FCC compliance and negate your authority to operate the
product.
Note: This equipment has been tested and found to comply with the lim-
its for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits for a signed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct the
This device may not cause harmful interference and
This device must accept any interference received, including inter-
1.
FCC statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
2.
ference that may cause undesired operation.
interference by one or more of the following measures:
•
•
•
• Consult the dealer or an experienced radio / TV technician for help.
T his device complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
FCC ID: 2ACVC-ABEATQI