6 7
www.holsteinhousewares.com
www.holsteinhousewares.com
9 . Pour in the batter into the lower plate; do not overll as the batter will
expand as it cooks.
10. After the cake pops are ready, carefully remove them by using an oven
mitt and a heat resistant wood or plastic spatula. DO NOT use metal
utensils because they will scratch and damage the non-stick coated
surface.
11. If cooking more than one batch in a session, after removing the rst
batch, allow the appliance to cool for 5 minutes before the next batch.
NOTE: DO NOT USE THE APPLIANCE FOR MORE THAN 15 MINUTES
NON-STOP.
12. As soon as you are nished cooking, unplug the appliance and allow it to
cool down.
CLEANING
Proper maintenance will ensure years of service of your appliance. Clean the
appliance after every use following these steps. This appliance contains no
user serviceable parts and requires little maintenance.
WARNING: The surfaces of the item will get very hot during use,
unplug the appliance and allow cooling before cleaning.
1 . Clean the interior and exterior surfaces of the appliance with a damp
cloth or sponge. Wipe dry with a soft cloth.
2 . To remove dough baked onto the cooking surface, pour a small amount
of cooking oil onto the hardened batter. After 5 minutes, carefully wipe
with a paper towel or dry cloth.
3 . NEVER USE ABRASIVE CLEANERS OR SCOURING PADS TO CLEAN THE
APPLIANCE , AS THOSE MAY DAMAGE THE SURFACES.
CAUTION: The surfaces of the appliance get hot. To avoid accidental
burns, scalping or steam being released while cooking, always
manipulate the appliance by using an oven mitt.
FOR HOUSEHOLD USE ONLY
USING THE APPLIANCE:
1 . This appliance is intended ONLY for household use.
2 . Prepare cake pop mix following the recipe instructions.
3 . Release the safety lock and lift the lid to the open position.
4 . Coat the non-stick surface with a small amount of vegetable oil. This
can be done with a paper towel or with a non-stick cooking oil spray.
Wipe o any excess oil. It is recommended to periodically do this after
use to maintain the quality of the non-stick coating.
5 . Check and conrm the voltage of the appliance is the same as the
outlets. Then, plug electrical cord carefully into a separate outlet from
other appliances to prevent the circuit from being overloaded.
6 . Close the appliance after plugging in, and allow to pre-heat.
7 . The red indicator light will turn on as soon as you connect the
appliance. The green indicator light will turn on when the appliance
reaches the maximum operating temperature. The appliance is ready
to cook as soon as the green light turns on. Note: the green indicator
light will turn on and o; it does not reect cooking completion only
temperature cycles from min to max.
8 . Open the appliance carefully with an oven mitt, grabbing it by the cool
touch handle.