www.hvlgroup.com
FIXTURE INSTALLATION
1. Attach the MOUNTING PLATE (A) onto the junction box using the MOUNTING SCREWS (B). This
fixture is designed to be mounted on standard round or octagon junction box. The junction box must
be securely mounted to the structure of the building.
2. Open the end link on the CHAIN (I) and attach to the loop on the FIXTURE ASSEMBLY (J). Hang the
FIXTURE ASSEMBLY (J) on the CHAIN (I) at your desired height, and remove excess CHAIN (I).
3. Feed the wire through the CHAIN (I) , SCREW COLLAR (G), CANOPY (H), SCREW COLLAR LOOP (F),
NIPPLE (E), and MOUNTING PLATE (A), and screw the NIPPLE (E) onto the MOUNTING PLATE (A).
4. Open the top link on the CHAIN (I), and Hang the FIXTURE ASSEMBLY (J) to the SCREW COLLAR
LOOP (F).
5. Cut off excess wire, and strip the insulation off the end of the leads.
6. Attach the Ground wire (Green) to the ground inside the junction box (Generally green or bar copper
wire) or the GROUND SCREW (C) on the MOUNTING PLATE (A). NEER CONNECT GROUND WIRE
TO "HOT" WIRE FAILURE TO FOLLOW THIS COULD RESULT IN SERIOUS INJURY OR DEATH
7. Connect the fixture lead the ridge(s) to the neutral (Generally white) wire in the outlet box. Fasten the
wires together with an approved fastener (WIRE NUT) (D). Starting 1" below the fastener, tightly wrap
the connection with electrical tape so that the connections seals the end of the fastener. MAKE SURE
THERE ARE NO EXPOSED WIRE OF STRANDS THAT COULD CAUSE A DANGEROUS SHORT CIRCUIT
8. Connect the smooth fixture leads with to the hot (Generally black) wire in the junction box. Fasten the
joined wires same as previous step. NEER REERSE HOT AND NEUTRAL WIRES. FAILURE TO
FOLLOW THIS COULD RESULT IN SERIOUS INJURY OR DEATH
9. Push the wires back into the junction box. Lift up the CANOPY (H) up to the ceiling, and secure with
the SCREW COLLAR (G).
10. Plate the METAL RING (J) on the GLASS (K), then lift the GLASS (K) up to the FIXTURE ASSEMBLY (J)
and secure with the SILICONE WASHER (L) and SOCKET RING (M).
11. Screw the BULB (N) into the SOCKET of the fixture. THIS FIXTURE IS RATED FOR 60 WATT TYPE G25
LAMP. DO NOT EXCEED THE RECOMMENDED WATTAGE
12. Restore power to the outlet at the breaker or fuse box.
ALAINA
H668701S
Installation Instructions
A
B
C
D
E
F
G
H
I
J
J
K
L
M
N
PART(S) REPLACEMENT PART NAME NUMBER
A,B,C,D,E,F,G HARDWARE KIT HDW-H668701S
H CANOPY CPY-H668701S
I CHAIN CHN-H668701S
K GLASS GLS-H668601
L SILICONE WASHER WAS-H668701S
J SOCKET RING RNG-H668701S
N BLB-60W-G25 BLB-H668601