Nomenclature
Forward
Important!
Focusing
Recommended Focusing Screens
Using Filters
Composing (Illust. B)
Lens barrel
Minimum aperture lock lever
Lens hood
Distance scale
Length index line/Aperture index/
mounting index*
Infrared compensation index
(white dot)
Distance scale window
Focus(ing)ring
Aperture scale
Aperture indexing post
Aperture-direct-readout scale
CPUcontacts
Depth-of-field sdale
Meter coupling ridge
Aperture ring
Thank you for your kind patronage of Nikon.
Before using your new lens, read the following carefully so you get the
most out of your lens now and for years to come.
Unlike other Nikkor fisheye lenses producing a circular image, the AF
Fisheye-Nikkor 16mm f/2.8 D lens fills up the frame with an image. But it
still possesses a 180° angle of view (as measured across the diagonal)
and gives you the same exciting fisheye effects as regular fisheye lenses.
Also, distance information used for 3D Matrix Metering or the 3D Multi-
Sensor Balanced Fill-Flash will be transmitted instantly from the lens to
the camera body.
• Be careful not to soil or damage the CPU contacts.
• Do not attach the following accessories to the lens, as they might
damage the lens’ CPU contacts:
Auto Extension Ring PK-1, Auto Extension Ring PK-11*, K1 Ring, Auto
Ring BR-4**
•
This lens cannot be used with AF Finder DX-1 attached to the Nikon
F3AF camera.
*Use PK-11A instead.
**Use BR-8 instead.
With the Nikon autofocus cameras, both autofocus and manual operations
are possible. To focus manualy, rotate the focus ring until the image in
the viewfinder appears sharp and crisp.
Various interchangeable focusing screens are available for Nikon cameras
to suit any type of lens or picture-taking situation. Those which are
recommened for use with your lens are listed on page 24.
As standard equipment, four rear-mounting bayonet-type filters (137C,
A2, B2 and 056) are supplied with the AF Fisheye-Nikkor 16mm f/2.8 D
lens. Because of the optical construction of this lens, it is necessary to
keep a filter attached to the lens at all times.
To exchange filter
(1) Rotate the already-attached filter counterclockwise to remove.
(2) To attach the filter, align the dot on the outside rim of the filter and the
groove beside the mounting pin on the lens bayonet, then rotate the
filter clockwise.
With a non-TTL exposure meter
Exposure compensation is required. Refer to table below:
Using a fisheye lens requires much more e planning and thought about
picture composition than does a conventional lens. The lens not only
produces wide-angle distortion but it also exaggerates the relative size of
objects to conform to its format: objects near the center are bigger than
those at the edges, and they show less optical distortion. The entire field
is pushed into the distance and spatial relations are transformed. and with
a slight shift of the camera, quite new distortions are created. Be careful
not to accidentally include in the picture unwanted ovjects, such as the
l
egs of a tripod or the hands or feet of the photographer.
Lens Care
• Clean lens surface with a blower brush. To remove dirt and smudges.
use a soft, clean cotton cloth or lens tissue moistened with ethanol
(alcohol) or lens cleaner. Wipe in a circular motion from center to outer
edge, taking care not to leave traces and not to touch the other lens
parts.
If you use ether in cleaning the lens, a smudge sometimes appears on
the surface of a multi-coated lens. If this happens, wipe it again with a
cotton cloth moistened with alcohol.
• Never use thinner or benzine to clean the lens.
• Keep the lens cap in place whenever the lens is not in use.
•
If you will not use the lens for a long time, protect it from rust and mold
by storing it in a cool, dry place. Also, do not store in direct sunlight,
and keep it away from naphthalene or camphor.
• Be careful not to get the lens wet or drop it in water. Water on the lens
may cause malfunction.
• Reinforced plastic is used on the exterior of the lens unit; to avoid
damage, take extra care to never leave the lens in an excessively hot
place.
Film
Filter
Compensation value (Filter factor)
Type Designation Daylight Tungsten light
Ultraviolet L37C
A2
B2
O56
1
1.2 (
1
/3)
1.2 (
1
/3)
1
1.2 (
1
/3)
1.2 (
1
/3)
3.5 (1
5
/6)2 (1)
Light Amber
Light Blue
Orenge
B/W and color film
B/W film only
Color film only
( )
=
Exposure compensation in f/stops
Minimum Aperture Lock (Illust. A)
For programmed auto or shutter-priority auto shooting, use the minimum
aperture lock lever to lock the lens aparture at f/22.
1. Set the lens to its minimum aperture (f/22).
2. Slide lock lever in the direction of the aperture ring and so the white dot
on the lever aligns with the orenge dot.
(See illust.A)
3. To release the lock, slide lever in reverse direction.