Kichler Lighting 15843TZT Manual de usuario

Tipo
Manual de usuario

Este manual también es adecuado para

INSTALLATION INSTRUCTIONS
Model 15843R (CP300228)
SAFETY INSTRUCTIONS
READ THIS FIRST
KEEP THESE INSTRUCTIONS
This fixture is intended for installation in accordance with the
National Electric Code (NEC) and Local code specifications.
Failure to adhere to these codes and instructions may result in
serious injury and/or property damage and will void the warranty.
1) WARNING: This fixture is not to be installed within 10 feet (3M)
of a pool, spa or fountain.
2) This fixture is to be used only with a power unit (transformer)
rated a maximum of 300 W (25 AMPS) 15 volts.
3) The #18 ga. fixture wire is not intended for direct burial.
4) Direct burial rated wire is to be buried a minimum of 6"
(152mm) beneath the surface of the ground.
NOTE: If additional Direct Burial wire is needed, contact your
local Kichler
®
landscape distributor.
•8GAwirecanbepurchasedinlengthof250’(76M),15503-BK.
•10GAwirecanbepurchasedinlengthof250’(76M),
15504-BK.
•12GAwirecanbepurchasedinlengthsof100’(30M),
15501-BK;250’(76M),15502-BK;500’(152M),15505-BK;and
1000’(304M),15506-BK.
5) Fixture shall not use a tungsten halogen lamp unless the fixture
is marked for use with such lamps.
6) Wiring connections must be made with approved/listed wire
connection device(s) suitable for the application. Do not exceed
manufacturers’wiringcombinationspecicationsforsizeand
quantity of conductors.
CAUTION
WHEN INSTALLING KICHLER LANDSCAPE LIGHTING (LINE VOLTAGE OR LOW
VOLTAGE), CARE SHOULD BE TAKEN TO KEEP CLEAR OF POTENTIALLY COM-
BUSTIBLE MATERIALS.
WHEN MAINTAINING THE FIXTURES, BE SURE TO REMOVE LEAVES, PINE
NEEDLES, GRASS CLIPPINGS, MULCH, OR ANY DEBRIS THAT HAS ACCUMU-
LATED ON THE LIGHT BULB, LENS, OR BODY OF THE FIXTURE.
ASSEMBLY AND INSTALLATION
1) Determine desired location for mounting fixture.
2) At desired location, hammer stake (A) into ground. To avoid
damage to stake, place a board on top of stake while hammering.
If ground is hard and stake is difficult to install, make a crosscut
in ground using a flat shovel.
3) Clear away area in ground at wireway slot (B) in top of stake (A).
4) Lay 12V cable into wireway slot (B) and screw stem (D) into
stake (A). If assembly does not look straight, adjust by pushing
or pulling on stake only.
5) Screw shade (C) onto stem (D).
6) TURN OFF POWER.
7) Makewireconnectionsusingsuppliedwirenutsfollowing
instructions on bag.
INSTRUCCIONES PARA INSTALAR
Model 15843R (CP300228)
INSTRUCCIONES DE SEGURIDAD
PRIMERO LEA ESTO
GUARDE ESTAS INSTRUCCIONES
Este artefacto se debe instalar de acuerdo con el Código
Eléctrico Nacional (NEC, por sus siglas en inglés) y con las
especificaciones del código local. No cumplir con estos códigos
e instrucciones puede resultar en lesiones graves y/ o en daños
a la propiedad y anulará la garantía.
1) Advertenciaertencia: Este artefacto no debe instalarse a menos
de 10 pies (3 m) de una piscina (alberca), spa o fuente.
2) Esteartefactodebeutilizarsesolamenteconunaunidadde
potencia (tranformador) con capacidad nominal máxima de 300
vatios (25 amp.) 15 voltios.
3) El alambre del artefacto calibre No. 18 no es para soterrado
directo.
4) El alambre clasificado para soterrado directo se debe enterrar
un mínimo de 6 pulgadas (152 mm) debajo de la superficie del
terreno.
NOTA: Si necesita alambre de soterrado directo adicional,
comuníquese con su distribuidor local Kichler® de productos de
jardinería ornamental.
Elalambrecalibre8puedecomprarseenlongitudde250’(76m.),
15503-BK
•Elalambrecalibre10puedecomprarseenlongitudde250’
(76m.),15504-BK
Date Issued: 12/12/14 IS-15843R-US
A
B
D
C
For warranty information please visit: http://www.landscapelighting.com/portal/warranty_page
Para informacion de la garantia por favor visite: www.landscapelighting.com/portal/warranty_page
•Elalambrecalibre12puedecomprarseenlongitudesde75’
(22m.),15550-BK;100’(30m.),15501-BK;250’(76m.),15502-BK;
500’(152m.),15505-BK;y1000’(304m.),15506-BK.
5) Elartefactonodebeutilizarseconlámparasdehalógeno,a
menoss que el artefacto esté marcado para usar con tales
lámparas.
6) Las conexiones de cableado se deben hacer con las conexiones
del(los)dispositivos)deconexióndecableadoaprobados/de
lalista,adecuadosparalaaplicación.Noexcedalasespecicaciones
decombinacióndecableadodelfabricanteparaeltamañoy
cantidad de conductores.
PRECAUCION
CUANDO SE INSTALE SISTEMAS DE ALUMBRADO KICHLER PARA JARDINES (YA
SEA DE VOLTAJE DE LINEA O CON VOLTAJE BAJO) SE DEBE TENER CUIDADO DE
MAINTNERLOS ALEJADOS DE MATERIALES QUE PUEDAN SER COMBUSTIBLES
EN POTENCIA.
AL DAR SERVICIO DE MANTENIMIENTO A ESTOS SISTEMAS, ASEGURESE DE
DESPEJAR LAS HOJAS, CONOS DE PINO, RECORTES DEL PASTO, CUBIERTA DE
PAJA O CUALQUIER BASURA QUE SE HAYA ACUMULADO EN LA BOMBILLA DE
LUZ, EL LENTE O EL SOPORTE DE LA BOMBILLA.
MONTAJE E INSTALACIÓN
1) Determine el lugar deseado para montar el artefacto.
2) En el lugar deseado, martille la estaca (A) en el suelo. Para
evitardañarlaestaca,coloqueunatablaenlapartesuperior
de la estaca mientras esté martillando. Si el suelo es duro y es
difícilinstalarlaestaca,hagauncortecruzadoenelsuelo
usando una pala plana.
3) Limpie el área del suelo en la ranura (B) del canal de alambres
en la parte superior de la estaca (A).
4) Coloque el cable de 12 V en la ranura (B) del canal de alambres
y atornille el vástago (D) en la estaca (A). Si el montaje no se ve
derecho, ajuste empujando o estirando de la estaca solamente.
5) Atornille la pantalla (C) en el vástago (D).
6) APAGUELAALIMENTACIÓNELÉCTRICA.
7) Haga las conexiones de cableado usando las tuercas para
cables suministrados siguiendo las instrucciones de la bolsa.
Were here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
  • Page 1 1

Kichler Lighting 15843TZT Manual de usuario

Tipo
Manual de usuario
Este manual también es adecuado para

En otros idiomas