Adventuridge 93410116 Manual de usuario

Marca: Adventuridge

Modelo: 93410116

Tipo: Manual de usuario

8 PERSON 14 ft. x 10 ft. 2 ROOM TENT

User Manual

Manual

del usuario

English. . . . . . . . . . . 3

Español . . . . . . . . . . 8

CARPA DE 2 HABITACIONES PARA 8 PERSONAS 14 pies x 10 pies

Contents

Parts List ...............................3

Safety & Care............................4

Assembly Instrucons . . . . . . . . . . . . . . . . . . .5-6

Tent Folding Instrucons . . . . . . . . . . . . . . . . . . 7

Warranty ........................... 14-17

MODEL NO. 93410116, 14 ft. x 10 ft.

DESCRIPTION

Main Pole

Side Pole

Front Awning Pole

Complete Frame

Guy Ropes

Steel Stakes

93410115M

93410115S

93410115A

93410115ST

A1001

PIN STAKE

PART NO.

KEY

NO.

QTY

REQ.

Parts List

DO NOT LEAVE YOUR TENT SET UP IN DIRECT

SUNLIGHT LONGER THAN NECESSARY. THE SUN’S

ULTRAVIOLET (UV) LIGHT DEGRADES ALMOST

EVERY FABRIC AND MATERIAL. IF LEFT IN

SUNLIGHT FOR PROLONGED PERIODS OF TIME,

FABRIC WILL FADE AND WEAKEN. DO NOT STORE

TENT ON CONCRETE FLOOR. DO NOT SPRAY THE

TENT WITH INSECTICIDE.

Your tent is water repellent, however, it is not waterproof.

During heavy rain, some leakage may occur. Keep

objects from touching the inside of the tent. Such

objects may cause leakage at point of contact. If seam

leakage occurs, it can be controlled by applying a seam

sealer compound.

EXERCISE CARE WHEN USING ELECTRIC DEVICES

IN AND NEAR TENTS.

Although our tents and screen houses are constructed to

rigid specifications, periods of wind or rain soaking the

ground may loosen the stakes and cause the uprights to

sink into the ground. This will weaken the rigidity of the

overall structure. Water pockets may also form in the

roof if the unit is not assembled taut, possibly causing

broken frames and torn fabric.

SAFETY WARNING -

Do’s and Do Not’s

CARBON MONOXIDE GAS WILL KILL YOU

Stoves, heaters, grills, lantern, candles, and other fuel-burning devices that

burn propane, natural gas, charcoal, kerosene, coal, or other fuels produce a

toxic gas called carbon monoxide. Because carbon monoxide gas is invisible,

odorless, and colorless, a dangerous level of carbon monoxide gas can

accumulate in a tent which cannot be detected by sight, smell, or taste. For

these reasons:

• DO NOT use matches, lighters, stoves, heaters, grills, lanterns, candles,

cooking equipment, or other fuel-burning devices inside or near a tent.

• DO NOT build fires inside or near a tent.

• DO NOT leave campfires unattended.

Your failure to follow this warning will cause death, serious injury, or permanent

disability to you or others.

PROTECT YOUR CHILDREN

• DO NOT leave children unattended inside a tent or in camp.

• DO NOT allow children to assemble a tent.

• DO NOT allow children to enter or exit a tent except through the door.

• DO NOT allow children to remain in a closed-up tent on hot days.

Your failure to follow this warning will cause death, serious injury, or permanent

disability to your children.

FLAMMABILITY WARNING KEEP ALL FLAME AND

HEAT SOURCES AWAY FROM THIS TENT FABRIC

This tent is made with flame resistant fabric which meets CPAI-84 specification.

IT IS NOT FIREPROOF. The fabric will burn if left in continuous contact with

any flame source. The application of any foreign substance to the tent fabric

may render the flame-resistant properties ineffective.

Your failure to follow this warning will cause death, serious injury, or permanent

disability to you or others.

CAMPING DO’S AND DON’TS

DO NOT...

1. Do not pitch tent near open fire.

2. Do not leave campfire unattended.

3. Do not leave children unattended inside a tent.

4. Do not use heating, lighting or cooking equipment with open flames

in or near tents.

5. Do not use other than recommended water repellent compounds

on your tent.

6. Do not spray the tent with insecticide.

7. Do not store tent on concrete floor.

DO...

1. Always extinguish campfire before leaving area.

2. Exercise care when using electricity and lighting in and near tents.

3. Make certain your tent is properly ventilated in all weather conditions. In

extreme weather conditions, snow could obstruct airflow and cause

asphyxiation unless cleared frequently.

EVERYONE WHO USES THIS TENT SHOULD READ THIS

MANUAL AND BECOME FAMILIAR WITH ALL SAFETY

WARNINGS AND PRECAUTIONS FOR SAFE USE,

ASSEMBLY, CARE, MAINTENANCE, AND STORAGE.

KEEP THIS MANUAL SO YOU CAN REFER TO IT LATER.

4. Anchor your tent securely to provide additional security

from changing climatic conditions. Snow pegs, skis and/or

heavy rocks may be necessary to supplement tent stakes

and guy ropes.

5. Take your tent down and store properly after camping.

DANGER

Send your request for parts to:

Exxel Outdoors, LLC.

6235 Lookout Road, Boulder, CO 80301

DANGER

WARNING

CARE

Folding Instructions

Safety & Care

STEP 1: Spread tent out flat, floor side down.

STEP 2: Extend fiberglass tent poles by pulling out each section

and placing it into the metal ferrule connectors. You will have five

poles. The two longest poles (A) are the main tent poles. The next

pair of poles (B) will be used on the sides of the tent. The single

pole with pre-bent ferrules (C) will be used for the front awning on

the tent fly.

STEP 3: While making

sure sleeves are in line

with each other, slide the

main fiberglass tent poles

(A) through the sleeves

that are opposite each

other on the roof of the

tent. Straighten

the

sleeves along the fiberglass sections. Position poles so that they

form an “X” across the tent.

STEP 4: Starting at the back of the tent,

place the ferrule at the end of the poles

onto the pins located on the rings at the

edge of the tent.

STEP 5: (Please read and follow IMPORTANT SAFETY

WARNING that appears before Step 1.) While one adult holds the

end of the tent pole firmly in place on the pin at the rear of the tent,

the other adult should now go into the front door of the tent

and gently lift the roof at the crossed tent poles off the

ground

. When the tent and poles are raised, the first adult who is

at the rear of the tent, goes to the front of the tent, flexes the

fiberglass pole and places the metal ferrule at the end of the main

tent pole onto the pin located on the ring at the base of the tent.

Repeat step for the other main tent pole. Clip

plastic hooks to the fiberglass frame poles.

Locate the fabric ties

attached to the

center of the tent

roof and tie both

poles together.

STEP 6: Stake down tent by

inserting the steel stakes through

the metal rings and stake loops

attached at the base of the

tent. Hammer stakes into

ground at a 45° angle by

using a hammer or mallet.

Make sure to pull tent out even

and tight.

IMPORTANT:

WE ADVISE YOU TO ASSEMBLE THE

TENT ONCE BEFORE GOING CAMPING TO BECOME

FAMILIAR WITH THE ASSEMBLY OF THE TENT.

NOTE: PLEASE LOOK AT THE REPLACEMENT

PARTS DIAGRAM TO SEE HOW YOUR FRAME IS

ASSEMBLED.

TO PROLONG THE LIFE OF THE TENT FLOOR,

SELECT A LEVEL, CLEAN AREA FOR THE CAMPSITE.

TO PREVENT DAMAGE TO THE ZIPPER, UNZIP THE

DOORS TO ALLOW AIR TO ENTER THE TENT.

TO IMPROVE THE WEATHER RESISTANCE OF YOUR

TENT, IT IS ADVISABLE TO USE SEAM SEALER TO

COAT ALL EXPOSED SEAMS. YOU SHOULD APPLY

ONLY TO THE INSIDE SEAMS OF THE TENT AND

UNDERSIDE OF THE TENT FLY. IF APPLIED TO THE

OUTSIDE OF SEAMS, DISCOLORATION OF YOUR

TENT MAY OCCUR. SEAM SEALER IS AVAILABLE IN

THE CAMPING SECTION OF ANY LOCAL SPORTING

GOODS STORE.

WARNING: During assembly of the main room and

side room tent pole, the tent poles are in tension. If the

poles are not held firmly in place by adults during assembly,

the tension in the poles may cause them to break or one end

of the pole to flip up, which could cause serious injury to you

or others involved in assembling the tent. To avoid this

hazard:

• DO HAVE two adults involved in assembling the tent.

• DO HAVE one adult hold the end of the tent pole in

place in the grommets at the crossed tent poles. When

the tent and poles are raised, the first adult who is at

the rear of the tent, goes to the front of the tent and

completes the pole connection into the grommets at the

front of the tent.

Failure to follow this warning could cause serious injury to

you or others involved in assembling this tent.

A ABB

Tent should appear

as shown.

STEP 7: (Please read and follow the IMPORTANT SAFETY

WARNING that appears before Step 1.) To assemble the side

rooms, locate the longer remaining pair of fiberglass poles (B).

Insert one of the pole sections through pole sleeve at the top of the

side room. With an adult on each end of the side room pole,

gently flex the pole into an arch and place the metal tips at the end

of the side room poles onto the pin located on the ring at the base

of the tent. Clip plastic hooks to the fiberglass frame poles.

Repeat the same procedure for the remaining side room.

STEP 8: Place fly over tent so the

front awning is located over the

front of the tent. Attach the fly to

the tent by hooking the

S-hooks located at the fly

corners to the metal rings at the

base of the tent.

WARNING: Elastic cords can snap back and hit your eye.

To reduce the risk of injury to you and others:

• Keep your body and face clear.

• Do not over stretch elastic cords.

• Maintain firm grip on hook.

• Pull the hook toward you; if it slips it will spring away from you.

• Make sure hook is fully clipped to tent before releasing.

• Wear protective eyewear during tent assembly.

Your failure to follow this warning could cause serious injury or

permanent disability.

STEP 9: Insert the fly awning (C) pole into the sleeve at the front

of the fly. Insert the pole ends onto the pins at the base of the tent.

STEP 10: Stake down the vestibule by inserting the stakes

through the stake loops and hammer the stakes into ground at a

45° angle.

STEP 11: Fasten the Velcro

fasteners on the underside of the fly

to the fiberglass poles at all locations.

STEP 12: There are guy ropes located on the front of the

awning and at the ends and back of the tent. Extend the guy

ropes and make a loop at

opposite end of guy rope by

using the slider (as shown)

and place the loop over the

steel stake. Adjust slider to

make guy rope tight and

stake to the ground at a

45° angle.

STEP 13: A divider curtain has been provided with this tent. To

attach it push the hooks through the corresponding loops on the

inside of the tent. A mesh gear loft is also included for the tent

ceiling to hold small items within easy reach.

NOTE: To take down tent, follow steps above in the reverse

order. Be sure to leave door and windows unzipped. Place stakes

into stake bag and poles into pole bag, which are provided. The

tent should be folded into equal parts toward the center of the

tent to distribute the bulk. Fold fly and lay on top of tent. Start a

small tight roll, the width of your carry bag, at the end opposite

the doors. Roll tent toward doors to allow air to escape. Once

rolled, tie a string or rope around tent to hold into place. Place

tent and stake bag into carry bag. Make sure tent is clean and

dry before storing.

Assembly Instructions

Tent should appear as shown.

Assembly Instructions