Westinghouse 5104800 Guía de instalación

Tipo
Guía de instalación
LED 5” & 6” RETROFIT TRIM INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need
them at a later date.
GENERAL: All electrical connections must be in accordance with local and National
Electrical Code (N.E.C.) standards. If you are unfamiliar with proper electrical wiring
connections obtain the services of a qualified electrician.
Remove the trim from the box and make sure that no parts are missing by referencing
the PARTS illustrations.
THIS RETROFIT ASSEMBLY IS ACCEPTED AS A COMPONENT OF A LED
LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION SHALL BE
DETERMINED BY CSA OR CANADIAN AUTHORITIES HAVING JURISDICTION.
WARNING: RISK OF ELECTRIC SHOCK. INSTALL THIS
TRIM IN RECESSED HOUSINGS THAT HAVE DIMENSIONS
SHOWN IN FIG. 1.
WARNING - Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge
of luminaire electrical systems. If not qualified, do not attempt installation. Contact a
qualified electrician.
WARNING - Risk of fire or electric shock. Install this kit only in the luminaires that have
the construction features and dimensions shown in the photographs and/or drawings.
Do not make or alter any open holes in an enclosure of wiring or electrical components
during kit installation.
WARNING - To prevent wiring damage or abrasion, do not expose wiring to edges of
sheet metal or other sharp objects.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTRALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED
ASSEMBLY AND INSTALLATION
INCANDESCENT HOUSINGS
1. Thread the SOCKET ADAPTER into the SOCKET. (FIG. 2)
2. Plug the FEMALE CONNECTOR of the RETROFIT TRIM onto the MALE
CONNECTOR of the SOCKET ADAPTER ASSEMBLY. (FIG. 3)
***For torsion spring option, please follow below steps.
3a.Squeeze both TORSION SPRING arms together and insert into the TORSION
SPRING SLOTS (or RECEIVER BRACKETS) of the recessed housing. Tuck all
wires into the recessed housing and carefully push the RETROFIT TRIM into
recessed housing. (NOTE: To provide enough room in shallow cans, carefully
position SOCKET ADAPTER and SOCKET adjacent to the long side of the LED
DRIVER prior to inserting the RETROFIT TRIM into the recessed housing.) (FIG. 4a)
Note: This fixture is 5" & 6" compatible.
For 5" installation, slide the springs to the position which marks 5".
(Refer to Fig 5a, 6a, 7a & 8a)
***For the clip option, please remove torsion spring and replace with clips.
3b. Squeeze both clip arms together and insert into the clip of the recessed housing.
Tuck all wires into the recessed housing and carefully push the RETROFIT TRIM into
recessed housing. (NOTE: To provide enough room in shallow recessed housing,
carefully position SOCKET ADAPTER and SOCKET adjacent to the long side of the
LED DRIVER prior to inserting the RETROFIT TRIM into the recessed housing.)
(FIG. 4b)
Note: This fixture is 5" & 6" compatible.
For 5" installation, slide the clips to the position which marks 5".
(Refer to Fig 5b, 6b, 7b, 8b & 9b)
DIMMING
Although this product is compatible with most common residential type dimmers, dimming
performance depends on dimmer, dimmer setting (for dimmers with brightness range adjustments),
wiring method, and the number of LED modules. For best results, set dimmer position at maximum
before adjusting to a lower light level.
Recommended Dimmers (minimum load for four LED modules maybe required for optimal dimming
performance): Leviton: 6674, IPL06, DSL06-1L 6672-1LW; Lutron: TGCL-153PH, MACL-153M,
CTCL-153P, PD-6WCL
FIVE-YEAR LIMITED WARRANTY
Westinghouse Lighting warrants that this lamp will be free from defects in material and
workmanship and will work for 5 years (based on up to 3 hours average usage per day
for 7 days per week). If the product fails during the warranty period, return defective
product to retailer. Warranty terms and conditions of retailer apply. If
replacement product is not available at retail store, please contact
[email protected] or return the product in the original
package with receipt to manufacturer at: 12401 McNulty Road, Philadelphia, PA
19154-1029. This limited warranty does not cover lamps subject to accident, neglect,
abuse, misuse or acts of God. REPLACEMENT IS YOUR SOLE REMEDY. EXCEPT TO
THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTIES ARE
LIMITED TO THE DURATION OF THIS WARRANTY PERIOD. LIABILITY FOR
INCIDENTAL OR CONSEQUENTIAL DAMAGES IS EXPRESSLY EXCLUDED. Some
states do not allow exclusion of incidental or consequential damages, so the above
exclusion may not apply. This warranty gives you specific legal rights, but you may also
have other rights that vary from state to state.
Westinghouse Lighting, Philadelphia, PA 19154-1029, U.S.A.
www.westinghouselighting.com
, WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF
are trademarks of Westinghouse Electric Corporation.
Used under license by Westinghouse Lighting
All rights reserved.
Made in China
WARNING - RISK OF ELECTRIC SHOCK. DISCONNECT MAIN
POWER AT FUSE OR CIRCUIT BREAKER BEFORE INSTALLING
OR SERVICING THE FIXTURE.
ES-WH-046
FIG. 3
5 in. – 7 in.
5 in. – 6 in.
FIG. 1
HOUSING DIMENSIONS
FIG.
FIG. 5a FIG. 6a
FIG. 5b FIG. 6b FIG. 7b
6 inch
6 inch
FIG. 7a FIG. 8a
5 inch
FIG. 8b FIG. 9b
5 inch
4a
FIG. 2
PARTS
SOCKET
CLIPS
ADAPTER
ASSEMBLY
RETROFIT TRIM
FIG. 4b
Westinghouse Lighting, Philadelphia, PA 19154-1029, U.S.A.
www.westinghouselighting.com
, WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF
are trademarks of Westinghouse Electric Corporation.
Used under license by Westinghouse Lighting
All rights reserved.
Made in China
13 - 18 cm
(5 – 7 in.)
13 - 15 cm
(5 – 6 in.)
ES-WH-046
INSTRUCCIONES DE INSTALACIÓN DE ADAPTADOR DECORATIVO LED DE
13 - 15 CM (5 – 6 IN.)
Por favor lea detenidamente estas instrucciones y consérvelas para futura
referencia.
CONSIDERACIONES GENERALES: Todas las conexiones eléctricas deben cumplir con las
normas locales y el Código eléctrico nacional (National Electric Code, NEC). Si no tiene
experiencia con los métodos de instalación de cableado eléctrico, solicite los servicios de un
electricista calificado.
Retire el adaptador decorativo de la caja y asegúrese de tener todas las piezas comparándolas
con las ilustraciones de las PIEZAS.
ESTE ADAPTADOR DECORATIVO ESTÁ ACEPTADO COMO COMPONENTE DE UN
ARTEFACTO DE ILUMINACIÓN LED DONDE LA ADECUACIÓN DE TAL COMBINACIÓN
DEBE SER DETERMINADA POR LA CSA O LAS AUTORIDADES CANADIENSES
COMPETENTES.
ADVERTENCIA: RIESGO DE DESCARGA ELÉCTRICA. INSTALE ESTE
ADAPTADOR DECORATIVO EN ALOJAMIENTOS EMPOTRADOS QUE
POSEAN LAS DIMENSIONES QUE SE INDICAN EN LA FIG. 1.
ADVERTENCIA: Riesgo de incendio o descarga eléctrica. La instalación del juego de adaptador
decorativo LED requiere conocimientos sobre los sistemas eléctricos de iluminación. Si usted
no está calificado para hacerlo, no realice la instalación. Consulte a un electricista certificado.
ADVERTENCIA: Riesgo de incendio o descarga eléctrica. Instale este juego únicamente en los
artefactos de iluminación que poseen las características de construcción que se indican en las
fotografías o los dibujos.
No perfore ni altere ninguno de los orificios presentes en una caja para cableado o los
componentes eléctricos durante la instalación del juego.
ADVERTENCIA: Para evitar todo tipo de daño o desgaste de los cables, no los exponga a los
bordes de metal enchapado u otros objetos cortantes.
ESTE PRODUCTO DEBE SER INSTALADO DE CONFORMIDAD CON EL CÓDIGO DE
INSTALACIÓN PERTINENTE POR UNA PERSONA FAMILIARIZADA CON LA
CONSTRUCCIÓN Y OPERACIÓN DEL PRODUCTO Y LOS PELIGROS IMPLICADOS
MONTAJE E INSTALACIÓN
ALOJAMIENTOS INCANDESCENTES
1. Enrosque el ADAPTADOR PARA PORTALÁMPARAS en el PORTALÁMPARAS. (FIG. 2)
2. Enchufe el CONECTOR HEMBRA del ADAPTADOR DECORATIVO al CONECTOR
MACHO del CONJUNTO ADAPTADOR PARA PORTALÁMPARAS. (FIG. 3)
***Para la opción de muelle de torsión, siga los siguientes pasos.
3. Apriete los dos brazos de los RESORTES DE TORSIÓN para insertarlos en las RANURAS
PARA RESORTES DE TORSIÓN (o SOPORTES RECEPTORES) de el alojamiento.
Introduzca todos los cables en el alojamiento e inserte con cuidado el ADAPTADOR
DECORATIVO en el alojamiento. (NOTA: Para tener lugar suficiente en el alojamiento poco
profundas, coloque con cuidado el ADAPTADOR PARA PORTALÁMPARAS y el
PORTALÁMPARAS junto al lado más largo del CONTROLADOR DEL LED antes de
introducir el ADAPTADOR DECORATIVO en el alojamiento.) (FIG. 4a)
Nota: Este artefacto es compatible con alojamientos de 5" y 6". Para instalacioned de 5"
deslice los muelles a la posicion marcado 5". (Vea figuras
5a, 6a, 7a y 8a)
***Para la opción de presilla, quite el muelle de torsión y reemplácelo con las presillas.
3b.Aprieta ambos brazos de la presilla e insertalos en la presilla de el alojamiento. Mete
t
odos los cables demtro de el alojamiento y empuje con cuidado el adaptor decorativo LED
en el alojamiento. (Nota a proporcione suficiente espacio en alojamientos poco profundas,
coloque cuidadosamente el ADAPTADOR DE portalamparas adyacentes al lado largo del
controlador de LED antes de introducir el adaptor decorativo en el alojamiento.) (Figura 4b)
Nota: Este accesorio es compatible con 5 "y 6".
Para una instalación de 5 ", deslice las presillas a la posición que marca 5".
(Consulte la Fig. 5b, 6b, 7b, 8b y 9b).
CONMUTACIÓN DE LA INTENSIDAD
Si bien este producto es compatible con la mayoría de los conmutadores de intensidad de uso residencial
más comunes, su rendimiento en este sentido depende del conmutador, la configuración del conmutador
(en modelos con ajustes de los niveles de luminosidad), el método de cableado y el número de módulos
LED. Para obtener mejores resultados, coloque el conmutador en el nivel máximo antes de ajustarlo a un
nivel de luz más bajo.
Conmutadores de intensidad recomendados (podría ser necesaria una carga mínima de cuatros módulos
LED para lograr una óptima conmutación de la intensidad): Leviton: 6674, IPL06, DSL06-1L 6672-1LW;
Lutron: TGCL-153PH, MACL-153M, CTCL-153P, PD-6WCL
GARANTIA LIMITADA DE 5 AÑOS
Westinghouse Lighting garantiza que esta lámpara no presentará defectos de material o mano
de obra y funcionará por un período de 5 años (en condiciones de uso promedio de 3 horas
diarias durante 7 días a la semana). Si el producto falla dentro del período de la garantía,
devuelva el producto defectuoso al vendedor. Se aplican los términos y condiciones de garantía
del vendedor. Si no hubiera un producto de reemplazo disponible en la tienda del vendedor,
póngase en contacto con [email protected] o devuelva el producto
al fabricante en su empaque original con recibo de compra: 12401 McNulty Road, Philadelphia,
PA 19154-1029. Esta garantía no cubre lámparas que sufran daños por accidente, negligencia,
abuso, uso indebido o razones de fuerza mayor. EL REEMPLAZO ES LA ÚNICA OPCIÓN
DISPONIBLE. SALVO EN LA MEDIDA EN QUE LO PROHÍBAN LAS LEYES APLICABLES,
TODAS LAS GARANTÍAS IMPLÍCITAS SE LIMITAN A LA DURACIÓN DE ESTE PERÍODO DE
GARANTÍA. TODA RESPONSABILIDAD POR DAÑOS Y PERJUICIOS MEDIATOS O
FORTUITOS QUEDA EXPRESAMENTE EXCLUIDA. En algunos estados no se permite la
exclusión por daños y perjuicios incidentales o derivados, por lo que es posible que la anterior
exclusión no se aplique en su caso. Esta garantía le brinda derechos legales específicos pero
usted también podría tener otros derechos que varían de un estado a otro.
CONJUNTO ADAPTADOR
PARA PORTALÁMPARAS
DIMENSIONES DEL
ALOJAMIENTO
ADAPTADOR DECORATIVO
PRESILLA
FIG. 1
FIG. 2
PIEZAS
ADVERTENCIA: RIESGO DE DESCARGA ELÉCTRICA.
DESCONECTE LA ALIMENTACIÓN PRINCIPAL QUITANDO EL
FUSIBLE O APAGANDO EL CORTACIRCUITO ANTES DE INSTALAR
O REALIZAR TAREAS DE MANTENIMIENTO DEL ARTEFACTO.
FIG. 3
FIG.
FIG. 5a FIG. 6a
FIG. 5b FIG. 6b FIG. 7b
6 in. (15.2cm)
6 inch (15.2cm)
FIG. 7a FIG. 8a
5 in. (12.7cm)
FIG. 8b FIG. 9b
5 inch
(12.7cm)
4a FIG. 4b
  • Page 1 1
  • Page 2 2

Westinghouse 5104800 Guía de instalación

Tipo
Guía de instalación

En otros idiomas