Danze D502533BNT Guía de instalación

Categoría
Artículos sanitarios
Tipo
Guía de instalación
Single Handle Pressure Balance Shower
Faucet Only Trim Kit
Grifoía solo para grifo de ducha con balanceo
de presión de una manija
Mélangeur 2 trous avec régulateur de débit
pour douchette à simple poignée
Shown/Mostrado/Illustré
Pub No. IM-kit SO/10-14
D500533T/ D502533T/ D501533T/ D503533T
Cape Anne collections(where the sleeve or bonnet is visible under the handle)
Anne collection(where the bonnet nut is visible under the handle) are supplied with
are
Shut off the main water supply before installation by turning the valves clockwise.
Antes de realizar la instalación, cierre el suministro principal de agua girando las válvulas en sentido horario
Fermez l'alimentation principale en eau avant l'installation en tournant les valves d'alimentation dans le sens horaire
1.1: Before installing the escutcheon, remove the plastic cap from the plaster guard by twisting
the cap clockwise.
1. Installing the Escutcheon and Handle Assembly onto the Valve Body:
1.4: Install the handle assembly to the valve stem and tighten the set screw located on the
bottom of the handle. Install the insert after tightening the set screw to the stem.
Note:
Nota:
Remarque :
Install the showerhead and tighten with a wrench.
2. Installing the Showerarm with Trim Ring and the Showerhead
Apply pipe tape to the threads on both ends of the showerarm. Slide the shower trim ring
onto the showerarm and install the shower arm to the elbow located in the wall cavity.
Tighten and align this to sit horizontally. Before installing the showerhead, flush the shower
piping with water to clear any debris.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Danze D502533BNT Guía de instalación

Categoría
Artículos sanitarios
Tipo
Guía de instalación