Ceiling Fan and Fixture Support
MODEL 02525-11
FAN ATTACHES TO WOOD JOIST NOT
TO PLASTIC BOX
The Fan Master Jr.
®
is UL listed for fan support and exceeds the requirements of the National Electric Code
for fans weighing up to 70 lbs. and light fixtures weighing up to 150 lbs.
INSTRUCTIONS
Turn off electrical power at breaker!
1. With electrical power off, pull wires into box. Hold box firmly against ceiling joist and install the small screw in the center of
the hole (figure 1).
NOTE: Large mounting screws remain inside the box.
2. For New Construction applications, tuck wires into box and put Saf-T-Cap
®
on (figure 2). Saf-T-Cap
®
protects bolts and wiring
during painting and sheetrocking.
3. When ceiling is complete, remove cap and install fan mounting bracket (provided with the fan) using the two large mounting
screws (figure 3).
4. Complete fan installation and wiring according to fan or fixture manufacturer’s instructions.
figure 1
figure 3
figure 2
Westinghouse Lighting Corporation
Philadelphia, PA 19154-1099, U.S.A.
Westinghouse Lighting Corporation,
a Westinghouse Electric Corporation licensee
“Westinghouse” and “You can be sure. . . if it’s Westinghouse”
are all registered trademarks of Westinghouse Electric Corporation
© 2005 WESTINGHOUSE LIGHTING CORP.
Revised 1/05