1
Installation Instructions for
Waveform 1 Light Pendant
Pendant
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
Insert the shade into the socket assembly and secure it in place using the shade screws.
Secure the mounting plate to the electrical box with two mounting plate screws.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place with the
two thumb screws.
1
2
1A
LAMP
3
SHADE
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
1.2
P1372_P1373
P1372, P1373
SOCKET ASSEMBLY
MOUNTING PLATE SCREW
MOUNTING PLATE
1
2
4
5
6
7
THUMB SCREW
77
3
SHADE SCREW
JUNCTION BOX
2
GENERAL PRODUCT INFORMATION:
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for damp locations.
Incandescent version may be dimmed with a standard incandescent
dimmer. version may be dimmed with a dimmer. ConsultLED LED
lamp manufacturer for additional information.
This instruction shows a typical installation.