ROOMS TO GO 24019324 Assembly Instructions

Marca: ROOMS TO GO

Modelo: 24019324

Categoría: Chimeneas

Tipo: Assembly Instructions

ANTI-TIP

Part No. HB-488 (1Pc)

ASSEMBLY INSTRUCTIONS

Important:

Be sure to check all packing material carefully for small parts which may come

loose inside carton during shipment. Separate, identify and count all parts and metal hardware.

Compare with part list and hardware ilustrations to be sure all parts are present. If any part(s)

is missing or damaged, contact your dealer's customer service deparment. For efficient and

fast service, please indicate the model number and the parts needed.

ATTENTION:

Some lettered parts listed on the instruction sheets may not

be in the parts bag, they may already be assembled.

TOOLS REQUIRED

(Not included)

Phillips Screwdriver

MODEL No.LIN49-209/24019324

HARDWARE:

TV CONSOLE

Page 1 of 5

10MM HOLE PLUG GREY

Part No.

HCPH-G

Qty: (2 pcs.)

INSTALLED

PULL NICKEL

Part No. HBJ-01-03690

Qty: (2 pcs.)

INSTALLED

SCREW 8 x 32 x 5/8"

Part No. HCPP-05Z

Qty: (4 pcs.)

INSTALLED

FIRE PLACE INSTALLATION

STEP 1.

Remove central

back panel

and remove shelf using a

screwdriver.

STEP 2.

Place fireplace inside the cabinet

and slide back panel back in.

Page 2 of 5

FIREPLACE NOT

INCLUDED

WARNING INSTALL FURNITURE TIPPING RESTRAINT KIT

Warning Advertencia Avertissement

ANTI-TIP

Installation instructions:

This tip restraint must be attached to wall stub using 2” screw enclosed

1.Attach a bracket securely to the back top rail of the furniture using the 5/8” screw provided through the smaller hole.

2. Locate the other bracket on the wall over the wall stud and 2 inches below the mounting bracket secure to the back of

your unit. Attach to the wall stud using the 2’’ screw provided, through the smaller hole.

3. Place the furniture into position so both mounting brackets are vertically in line

4. Laces the end of the restraint strap though the larger hole in each mounting bracket. Bring both ends together and

slide the flat end through the looking end and flat draw it through until all slack is removed.

5. Confirm that the strap in securely laced and lacked.

Instrucciones de instalacion:

Este seguro contra volcado debe fijarse a un taco de pared con el tornillo de 2” que se incluye.

1. Coloque un soporte firmemente en la parte superior trasera del mueble ,usando el tornillo 5/8” que se proporciona y el

agujero mas pequeño

2. Ubique el otro soporte en la pared sobre un taco y 5cm (2pulg.) por debajo del soporte de montaje asegurado en la

parte bracera de la unidad .Fije al taco de pared usando el taco de 2’’ que incluye y el agujero mas pequeño .

3. Coloque el mueble en el sitio, de modo de modo que los dos soportes estén en una línea vertical.

4. Pase el extremo de una cinta de sujeción por el agujero más grande en cada soporte de montaje, una los dos

extremos y deslice el extremo plano por el lado del cierre, hasta que quede tenso.

5. Confirme que la cinta este bien asegurada.

Instructions d` installation:

Ce dispositif de sécurité doit être fixé au montai d` un mur a` l` aide de la vis de 5cm (2 po) fournie

1. fixer solidement un support a`la traversé supérieure du meuble, en passant la vis de 1,6cm (5/8 po) dans le plus petit

trou.

2. placer I` autre support sur un montant du mur, a` environ 5cm (po) plus bas, par rapport au premier support de fixation,

fixer ce support en passant la vis de 5cm (2 po) fournie dans le plus petit trou.

3. positionner le meuble afin d`aligner verticalement les deux supports de fixation

4. passer l`extrémité de i`attache dans les plus grands trous des deux supports. Joindre les extrémités insérer l`extrémité

plate dans le dispositif de blocage puis tirer au maximum pour desserrer.

5. vérifier que l`attache est solidement fixée et bloquée.

Page 3 of 5

STEP 1.

STEP 2.

STEP 3.

INSTRUCTIONS SHEET

ADJUSTABLE WOOD SHELF

Page 4 of 5

1 4

Directions of Adjusting

Euro Style Hinges

1.- PLEASE REMOVE SHIPPING

SCREW #1.

2.- LATERAL ADJUSTMENT

Turn screw #2 in or out to even

grasp along the side of the door.

3.- VERTICAL ADJUSTMENT

Loosen screw #3 to move door up or

down, then tighten securely. (There

are two screws for each hinge)

PAGE 5 OF 5

ROOMS TO GO 24019324 Assembly Instructions

Marca: ROOMS TO GO

Modelo: 24019324

Categoría: Chimeneas

Tipo: Assembly Instructions

Descargar PDF

informe

en otros idiomas

français: ROOMS TO GO 24019324
English: ROOMS TO GO 24019324

ROOMS TO GO 24019324 Assembly Instructions

ROOMS TO GO 24019324 Assembly Instructions

en otros idiomas

Artículos relacionados

Otros documentos